Idiomas disponibles
Idiomas disponibles
CHECKING AND MAINTAINING FILTER
Maintain the filter by checking it frequently. Depending on air quality conditions, you may need to
replace it more frequently. Vacuum the carbon filter layer as needed to remove loose debris and
dust and to help prolong the life of your filter. To check the status of the filter, peel back the carbon
layer to expose the pleated filter. If the filter is no longer white and is covered in grey dust/dirt, it
should be replaced.
IMPORTANT: Do NOT try to wash and re-use the Combination Filter.
IMPORTANT: Use Guardian Technologies GENUINE Replacement Parts only.
INSTALLING & REMOVING UV-C BULB
CHANGE BULB INDICATOR
The blue light on the front of air cleaner will begin to flash continuously when it is time to replace
the UV-C bulb. Replace the bulb according to the directions then press the UVC button and hold
for 3 seconds to restart the system. The light should remain a constant blue.
REPLACE BULB
3. After removing the
Combination Filter, use
a Philips head screw-
driver to remove two (2)
screws and detach the
UV-C Metal Shield.
6. Reassemble by reversing steps. Turn the unit back on and hold the UV-C control button for
3 seconds to reset UV-C indicator light.
IMPORTANT: The UV-C Bulb should be replaced every 10 - 12 months depending on use.
4. The UV-C Bulb is removed
by carefully grasping the bulb
with a clean cloth or tissue
and pulling the bulb straight
out of the unit.
E-7
1. Remove the Rear Cover of the unit by pushing
Lock & Release Button.
2. After removing the Rear Cover from the unit,
remove the Combination Filter.
PULL UV-C BULB
STRAIGHT OUT
OF UNIT
5. The UV-C Bulb is reinstalled
by sliding it, horizontally, back
into the slots at the top of
the unit.
Bulb is NOT visible until
the UV-C METAL SHIELD
has been removed.
