John Bean QUADRIGA 1000 Manual Del Operador página 88

88
5.2-11
5.2-12
5.2-13
5.2-14
Operations
• Then activate the Lever until the tools move to the
upper side of the wheel.
The machine stops automatically (and beeps).
• Lift the tire manually to create a space next to the
tool that it can enter (Fig.5.2-11).
• Activate the Lever again to insert the tool and the
disk between the tire and the rim (Fig.5.2-12).
The machine stops automatically (and beeps).
The operator must be able to:
• Operate rotation using the Pedal Command in
order to move the Pressure Sensor, if included, to
a suitable position in relation to the tool.
• Use one of the bead pushing aids supplied:
- Manual Clamp
- MH (Pneumatically-controlled Bead Pusher)
- Bead Pusher Inserts
Or a combination of the above (Fig.5.2-13).
• Complete the bead insertion procedure by
continuing rotation, making sure that the tool does
not collide with the bead pushing aids.
WARNING:
STOP ROTATION AT THE RIGHT MOMENT TO
AVOID THE BEADPUSHER AIDS COLLIDING
WITH THE TOOL.
Having completed mounting, to facilitate the removal
of the mounting aids:
• Rotate the wheel in the opposite direction, until it
reaches the bead breaking disk (Fig.5.2-14), as in
this position it is easier to remove.
• Activate the Lever again until the tools and disks
have left the work area and returned to the idle
position.
Note: When moving the tools, to speed up the
operating fl ow, the rotation pedal command
is enabled.
• Turn the wheel contemporaneously as the
tools movement, until the valve is close by for the
subsequent bead insertion operation.
When the tools reach the rest position, the machine
stops automatically (and beeps) and the "MANUAL
MODE" message appears again on the Display.
Operator's Manual QUADRIGA 1000/BB