Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To install:
1. The key (Fig.14-A)
pan head screw (B)
and flat washer (C)
should already be at-
tached to the shaft.
2. Remove the pan head screw and flat washer.
Remove the tape from the key.
3. Insert the handwheel onto the shaft making
sure that the notch in the handwheel lines up
with the key on the shaft.
4. Fasten the handwheel to the shaft using pan
head screw and flat
washer removed in
step 2.
5. Thread the handle
(Fig.15-D)
into
the
threaded hole (E) in
the handwheel.
REAR ACCESS PANEL
The access panel needs to be installed on the
rear of the jointer base.
To install:
1. Place the bottom
edge of the access
panel (Fig.16-A) on
the lower edge of the
jointer base.
2. Lift up the access panel and fasten shut using
six M6x12mm pan head screws (B).
INFEED TABLE ADJUSTMENTS
To raise or lower the infeed table, loosen in-
feed table lock handle (Fig.17-B) and turn the
table raising and lowering handwheel (A) until
the table is at the desired position and tighten
infeed table lock handle.
D
C
Fig.17
C
A
B
Fig.14
D
E
Fig.15
B
A
Fig.16
B
A
E N G L I S H •
INFEED POSITIVE STOP
There is a safety fea-
ture that will not al-
low the infeed table
to drop below a 1/8-in
depth of cut. This stop
(Fig.18-A) is located
on the rear of the
jointer.
Once the jointer hits a depth of 1/8", the spring
loaded knob snaps into a hole in the infeed
table. To make the infeed table go lower than
this, you will have to pull out on the knob as
you lower the table.
OUTFEED TABLE ADJUSTMENTS
WARNING: DISCONNECT MACHINE FROM
POWER SOURCE.
The outfeed table must be exactly level with
the knives when the knives are at their high-
est point of revolution. To move the outfeed
table, loosen outfeed table lock handle (Fig.17-C)
and turn the table raising and lowering hand-
wheel (D) until the table is level with the
knives. When the outfeed table is exactly level
with the knives at their highest point of revolu-
tion, tighten outfeed table lock handle.
STRAIGHT KNIFE ADJUSTMENTS
CAUTION: Care must be taken when han-
dling the knives as the cutting edges are very
sharp. The quick change knives on your jointer
are double sided and are mounted on special
pins. These pins automatically set the knife at
its proper height, eliminating the need for a
knife gauge. While the knives on your jointer
come preinstalled at the factory, the following
procedures detail how to remove and install a
set of knives.
1. Start in the center
of the knife gib and
remove the M6x16mm
allen
head
screw
(Fig.19-A).
2. Alternate sides as you loosen the remaining
screws along the length of the gib
3. Remove the black knife gib. The knife below
can now be lifted off of the (2) locating pins.
4. Flip the knife over if necessary to expose
new edge nd mount the knife back on the (2)
locating pins.
U se r's m a nua l
A
Fig.18
A
Fig.19
25
Tabla de contenido
