Tabla de contenido
Idiomas disponibles
Idiomas disponibles
may not match the configuration of your exist-
ing outlet. If this is the case, you will have to
replace the plug with a UL/CSA approved plug
that matches the configuration of your 220 V
outlet.
GROUNDING INSTRUCTIONS
WARNING: This machine MUST BE GROUND-
ED while in use to protect the operator from
electric shock.
In the event of a malfunction or breakdown,
GROUNDING provides the path of least resis-
tance for electric current and reduces the risk
of electric shock. The plug MUST be plugged
into a matching electrical receptacle that is
properly installed and grounded in accordance
with ALL local codes and ordinances.
If a plug is provided with your machine DO
NOT modify the plug. If it will not fit your
electrical receptacle, have a qualified electri-
cian install the proper connections to meet all
electrical codes local and state. All connections
must also adhere to all of OSHA mandates.
IMPROPER ELECTRICAL CONNECTION of the
equipment-grounding conductor can result
in risk of electric shock. The conductor with
the green insulation (with or without yellow
stripes) is the equipment-grounding conduc-
tor. DO NOT connect the equipment-ground-
ing conductor to a live terminal if repair or
replacement of the electric cord or plug is nec-
essary.
Check with a qualified electrician or service
personnel if you do not completely understand
the grounding instructions, or if you are not
sure the tool is properly grounded.
PLUGS/RECEPTACLES
WARNING: Electrocution or fire could result
if this machine is not grounded properly or if
the electrical configuration does not comply
with local and state electrical codes.
• MAKE CERTAIN the machine is disconnected
from power source before starting any electri-
cal work.
• MAKE SURE the circuit breaker does not ex-
ceed the rating of the plug and receptacle.
The motor supplied with your machine is a 220
volt, 60 hertz, single phase motor.
E N G L I S H •
Never connect the green or ground wire to a
live terminal. A machine with a 220 volt plug
should only be connected to an outlet having
the same configuration as the plug.
EXTENSION CORDS
WARNING: To reduce the risk of fire or elec-
trical shock, use the proper gauge of extension
cord. When using an extension cord, be sure
to use one heavy enough to carry the current
your machine will draw.
The smaller the gauge-number, the larger the
diameter of the extension cord is. If in doubt
of the proper size of an extension cord, use a
shorter and thicker cord. An undersized cord
will cause a drop in line voltage resulting in a
loss of power and overheating.
CAUTION: USE ONLY a 3-wire extension
cord that has a 3-prong grounding plug and
a 3-pole receptacle that accepts the machine's
plug.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
3
2
1
11
9
10
1. OUTFEED TABLE.
2. FENCE.
3. CUTTERHEAD GUARD.
4. ON/OFF SWITCH.
5. INFEED TABLE.
6. INFEED TABLE RAISE/LOWER HANDWHEEL.
7. INFEED TABLE LOCK HANDLE.
U se r's m a nua l
4
5
6
7
8
12
21
Tabla de contenido
