Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8. DEPTH SCALE.
9. OUTFEED TABLE LOCK HANDLE
10. DUST PORT.
11. OUTFEED TABLE RAISE/LOWER HANDWHEEL.
12. MOBILE BASE FOOT PEDAL.
UNPACKING
IMPORTANT: The machine is heavy, two peo-
ple are required to unpack and lift. Use a safety
strap to avoid tip over when lifting machine.
Check shipping carton and machine for dam-
age before unpackaging.
packaging materials, parts and machine from
shipping carton. Always check for and remove
protective shipping materials around motors
and moving parts. Lay out all parts on a clean
work surface.
Remove any protective materials and coatings
from all of the parts and the jointer. The pro-
tective coatings can be removed by spraying
"Multipurpose lubricant" on them and wiping
it off with a soft cloth. This may need to be re-
done several times before all of the protective
coatings are removed completely.
After cleaning, apply a good quality paste wax
to any unpainted surfaces. Make sure to buff
out the wax before assembly.
Compare the items to inventory figures; verify
that all items are accounted for before discard-
ing the shipping box.
WARNING: If any parts are missing, do not
attempt to plug in the power cord and turn
"ON" the machine. The machine should only
be turned "ON" after all the parts have been
obtained and installed correctly.
A. Rear Panel (Al-
ready ensambled
with base 'H').
B. Cutterhead
guard.
C. V-belts (2).
D. Power Switch.
E. Dust Port.
F
G
22
Carefully remove
B
E
C
D
A
F. Table adjusting hand-
wheels (2).
G. Handles (2).
H. Jointer base.
J
K
L
I
R
S
T
W
I. T25 Star wrench
J. 3mm Allen Wrench
K. 4mm Allen Wrench
L. 5mm Allen Wrench
M. 8mm Allen Wrench
N. 12x14mm Open End Wrench
O. 13mm Open End Wrench
P. M8 Flat Washer (2)
Q. 5/16 Pan Head Screw (2)
R. M6x8 Pan Head Screw (4)
S. M10 Lock Washer (3)
T. 3/8-16 Stud (3)
U. M6x15 Soc Cap Screw (2)
V. M6 Ex-toothed Washer (2)
W. M6x10 Pan Head Flange Screw (4)
X. Key 5x5x22 (2)
Additional items;
Fence locking knob, fence adjusting knob,
knob washer, special nut, foot pedal, wheels
(2), M8 flat Washer (2), M8x50mm hex head
screw (2), leveling feet (2), M8 hex flange nut
(2), M8 x 20mm carriage bolt (2), cutterhead
pulley guard & Push Paddles (2).
ASSEMBLY
ASSEMBLING MOBILE BASE WHEELS
1. Turn the Base (Fig.1-
A) upside down and
mount the 2 non-
swiveling wheels (B)
to the base using one
M8x50mm Hex head
screw and one M8
flat washer for each
wheel.
M
N
O
P
Q
U
V
X
Fig.1
C
A
B
Tabla de contenido
