Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2. Fasten the special nut, to the bottom of the
fence locking handle
shaft. Make certain
that the two prongs
on the special nut face
upwards and fit into
the groove (Fig.8-C)
on the bottom of the
fence assembly.
ASSEMBLING CUTTERHEAD GUARD
WARNING: Make certain that the machine
is disconnected from the power source.
CAUTION: The cutterhead guard has a ten-
sion return spring. The tension on this spring is
set at the factory. When the guard is installed
properly it should return to the fence automat-
ically after the workpiece has passed over the
cutterhead. Be sure the guard is functioning
properly before using the jointer.
1. Move the fence all the way to the rear of the
table exposing the cutterhead.
2. Rotate the cutterhead by hand, using the
belt, until there are no blades exposed. If this
is not possible, place a thin piece of cardboard
over the cutterhead. This is done to avoid ex-
posure of hand to sharp Blade.
CAUTION: Care must be taken when your
hands are near the knives as the cutting edges
are very sharp.
3. Locate the mounting
hole (Fig.9-A) on the
right hand side of the
rabbetting ledge. Check
to make sure that the
locking set screw (B) is
not protruding into the
mounting hole at this
time.
4. Place the guard
above the table posi-
tioned over the cut-
terhead with curved
edge
against
fence
and drop the shaft
in the hole. The pin
(Fig.10-C) should be
below the surface of
the infeed table and pressed up against the
side of the jointer.
24
C
Fig.8
A
B
Fig.9
C
D
Fig.10
5. Tighten the set screw using the handle (D).
6. Check guard clearance to be sure it is not
dragging over table surface or cutterhead. If
the guard is too low, loosen the set screw and
raise the guard slightly.
Test the guard and be sure it springs back to
the fence when pulled out. Test with the fence
in its furthest position from the guard. Make it
a habit to check this important safety feature
every time before Using the jointer.
ASSEMBLING DUST PORT
1. The jointer stand has a built in dust chute.
If this machine is to be
hooked up to a dust
collection system, the
supplied
dust
port
can be fastened to
the jointer stand us-
ing four M6x8mm pan
head screws and four
flat washers (Fig.11).
2. A standard dust collection hose can now be
attached to this port.
NOTE: DO NOT ATTACH THE DUST PORT IF
YOU DO NOT PLAN TO CONNECT THE JOINTER
TO ADUST COLLECTION SYSTEM.
ATTACHING SWITCH
1. Locate the 2 threaded holes on the back side
of the infeed table.
2. Line up the two
holes on the switch
bracket
(Fig.12-A)
with the two threaded
holes in the jointer.
3. Fasten using two M6x15mm hex soc head
cap screws and two lock washers. Tighten se-
curely.
4. Insert the power
prong
(Fig.13-B)
of
switch
power
cord
into the prong (C) of
motor power cord .
HANDWHEEL ASSEMBLY
The purpose of the handwheels is to raise and
lower the outfeed and infeed tables.
The procedure for installation is the same
for both the infeed and outfeed sides of the
jointer.
Fig.11
A
Fig.12
B
C
Fig.13
Tabla de contenido
