AGP R16 Instrucciones De Seguridad página 16

E5 Excessive back voltage from the
motor brake to the converter
RCD current leak detection
E6 between the converter and the
voltage supply
E7 Hall effect sensor error
E8 Motor overheat
Loss of communication between
the converter electronics
E91 board and LCD module during
operation
Loss of communication between
the motor electronics board
E92 and the LCD module during
operation
E10 Poor connections of power
supply cable -single phase
E11 Voltage leak between the
converter and the tool
E12 Poor connections of power
supply cable –three phase
Internal problem in the
converter electronics board
E15 circuit
No signal from the motor
E16 temperature sensor
Motor temperature sensor short
E17 circuited
GB
At the converter, press the POWER button to turn the power
OFF and then back ON again
(If the problem persists, bring the unit to an authorized
service center for repair)
Check connections and then, at the converter, press the
POWER button to turn the power OFF and then back ON
again
(If the problem persists, bring the unit to an authorized
service center for repair)
At the converter, press the POWER button to turn the power
OFF and then back ON again
(If the problem persists, bring the unit to an authorized
service center for repair)
Ensure that water is flowing and wait 20 seconds.
Then, at the tool, turn the switch OFF and then ON again
(If the temperature has sill not dropped sufficiently after
20 seconds, wait longer for the temperature to drop to the
acceptable range)
At the converter, try pressing the POWER button to turn
the power OFF and then back ON again. (If the problem
persists, bring the unit to an authorized
service center for repair)
Check the connection of the coupling cable. Then, at the
tool, try turning the switch OFF and then ON again (If the
problem persists, bring the unit to an authorized
service center for repair)
Check the connections of the power supply plug and cable
Check connections and then, at the converter, press the
POWER button to turn the power OFF and then back
ON again (If the problem persists, bring the unit to an
authorized service center for repair)
Check the connections of the power supply plug and cable
At the converter, try pressing the POWER button to turn the
power OFF and then back ON again (If the problem persists,
bring the unit to an authorized
service center for repair)
At the tool, try turning the switch OFF and then ON again (If
the problem persists, bring the unit to an authorized service
center for repair)
At the tool, try turning the switch OFF and then ON again (If
the problem persists, bring the unit to an authorized service
center for repair)
16