Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Appendix
Maintenance
Simply wipe the base station and handset with a damp cloth or an antistatic wipe.
use a dry cloth as this can cause static discharge.
Never
Troubleshooting
If your telephone does not behave the way you want it to, first try to solve the prob-
lem using the following list.
Fault
No display
No reaction to keystroke
No radio connection to the
base station – E.g. base sta-
tion 1 is flashing
Handset that is in the base
station is not charging
Handset does not ring
You cannot hear
The incoming call number is
not displayed although Cal-
ler ID is set.
The ringer/dialing tone
cannot be heard.
Error beep is generated (de-
scending tone sequence)
60
Possible cause
Handset not activated
Batteries empty
Keypad protection activated
Handset outside the base
station range
Handset not registered
Base station not activated
Line seized by a second
handset for a long period
Ringer off
The key
was pressed –
the microphone is "muted"
The telephone number
transmission is blocked
You have changed the tele-
phone cord on your Gigaset.
Wrong input
Solution
Hold down end call key
for 1 second
Charge or replace the batte-
ries (page 4)
A
Hold down the
key for
1 second
Move closer to the base sta-
tion
Register the handset
(page 38)
Check the connector at base
station (page 3)
Maximum charging power is
only possible while nobody
is making calls
Activate the ringer
B
Hold down the
key
Q
Press
, to activate the
microphone
The callers must permit the
transmission of their tele-
phone numbers at their net-
work provider
Ensure, when purchasing a
new cord, that it has the cor-
rect pin assignment (3-4 as-
signment of the telephone
leads/EURO CTR37).
Repeat the procedure; note
the display and, if necessary,
refer to the operating in-
structions
Capítulos
Tabla de contenido
