Idiomas disponibles
Idiomas disponibles
MODEL: PMPN
OPERATION
LUBRICATION
This tool requires lubrications before using the tool for
the first time and before each use. If an inline oiler is
used, manual lubrication through the air inlet is not
required on a daily basis.
1. Disconnect the air supply from the tool to add
lubricant.
We
—
2. Turn the tool so the air inlet is facing up. Place 2-3
drops of pneumatic fastening tool oil into air inlet.
Do not use detergent oils, oil additives, or air-tool
oils. Do not use detergent oil or additives as these
lubricants will cause accelerated wear to the seals
and bumpers in the tool, resulting in poor tool
performance and frequent tool maintenance.
3. After adding oil, run too briefly. Wipe off any excess oil
from the cap exhaust.
CAUTION:
The work surface can become
damaged
by
excessive lubrication. Proper lubrication is the
owner's responsibility. Failure to lubricate the
tool properly will dramatically shorten the life
of the tool and void your warranty.
10
HTTP:/WWW.
FREEMANTOOLS.
COM
1-888-669-5672
MODEL: PMPN
DRIVING A FASTENER
1. Connect the air supply to the tool.
ll
— HH
2. Load fastener into the palm nailer.
REEMAN
4, Align fastener and tool in the location where fastener
is to be driven.
6. Continue to apply pressure until fastener is driven
completely or until reaching desired penetration.
HTTP://WWW.
FREEMANTOOLS.
COM
1-888-669-5672
n
