RIDGID HD1612M0 Manual Del Usuario página 17

INTRODUCTION
TOOLS NEEDED
Phillips Screwdriver
UNPACKING
This Product Requires Assembly.
Check all parts from carton against the Carton Contents List.
If any parts are damaged or missing contact
01­800­701­9811 from Mexico or by email at
[email protected].
CARTON CONTENTS LIST (Fig. 1)
Key Description
A* Powerhead Assembly ..................................................1
B* Dust Drum ....................................................................1
C* Drain Cap ......................................................................1
D Carry Handle ................................................................1
E Pan Head Screws, #10 x 19 mm (3/4") ...................10
F Hose Storage Clips ......................................................2
G Caster Foot w/Storage .................................................4
H Casters ..........................................................................4
I* Qwik Lock™ Filter ........................................................1
J Tug­A­Long Positive Locking Hose with Dual­Flex ...1
K Extension Wands .........................................................2
L Utility Nozzle .................................................................1
M Owner's Manual ...........................................................1
* These parts come preassembled.
C*
D
E
F
G
H
SP7115-1 HD1612M0 SE.indd 17 SP7115-1 HD1612M0 SE.indd 17
Fig. 1
A*
I*
B*
J
K
L
M
ASSEMBLY
FRONT CASTER/CASTER FOOT ASSEMBLY (Fig. 2)
NOTE: Remove Powerhead Assembly from Dust Drum
prior to assembly of Casters and Caster Feet.
1. Place Caster Foot (G) upside down on the floor.
2. Place the Caster (H) into the Caster Foot (G): Insert
the Caster Stem into Caster Foot Socket.
3. Push on the Caster until the Caster Ball end snaps
fully into the Caster Foot Socket and the Caster
swivels freely. Repeat for other Three Casters and
Caster Feet.
4. Turn Dust Drum (B) upside down on floor.
Qty
5. Place Caster Foot with Caster over Drum Post and
press firmly in place. Repeat for the other Three
Caster/Caster Foot Assemblies (H & G).
6. Four Screws are available for optional assembly of
the Caster Feet into the Drum. If desired, locate the
Four #10 x 3/4" Pan Head Screws (E) in loose parts
bag. Insert a Screw through the Hole and into the
Dust Drum (B). Tighten securely.
7. Turn the Dust Drum (B) upright.
Caster Stem
(G)
Caster Foot
Socket
(B)
Drum Post
17
Fig. 2
(H)
(E)
Optional Hole for
Screw Placement
7/30/20 8:42 AM 7/30/20 8:42 AM