Idiomas disponibles
Idiomas disponibles
E: Air extraction function
By pressing the "AIR EXTRACTION FUNCTION" the product extracts air. In the case of several units, all of them extract air
simultaneously until another command is given by the user.
EN
Attention: the sensors are not active in this function.
Respuesta:
Light pulse on activating the mode
Periodic light pulse (every 1 min.) active mode
COMMISSIONING
• Every time you turn on the RESPIRO RD N (using the "0/1" switch) you have to wait 20 seconds before the unit will respond
to remote control orders.
During the fi rst 15s, the unit is powering up. In this state the red LED is on.
Once the red LED has turned off, another 5 seconds pass until we see a white blink.
Only after fl ashing white will the unit respond to remote control orders.
• It is important not to press any button until we have seen the white blink, otherwise the unit could be blocked.
• The fan may take up to a minute to start as it will not start rotating until the damper is fully open.
• Every time you send an order to the RESPIRO RD N, you are sure that the unit has received the order by checking that the
white LED blinks.
• Every time you unplug the unit, it returns to AUTOMATIC MODE at the next start-up.
FILTER ALARM RESET
Every 2000 hours of operation the indicator light at the bottom right will emit a continuous red light signal. The product will
continue to operate by keeping the last command received.
To reset the hour counter inside the unit, press the key sequence detailed below (refer to the image of the remote control
on page 1):
PRODUCT RESET
1. Turn on the unit using the "0/1" switch. The red LED lights up.
2. Press the "SUPERVISION MODE" button 5 times. It is important that no time elapses between step 1 and 2, otherwise you
will have to start over.
3. Wait 30 seconds. Verify that the red LED stays on permanently.
4. Turn off the unit with the "0/1" switch and leave it off for about 15 seconds.
5. Turn on the unit with the "0/1" button and do not press any button on the remote control.
6. Wait for the red LED to turn off, then wait for the LED to blink white after a few seconds.
7. Once the white fl ash is displayed, the unit will restart. Pay attention to the "START UP" paragraph before proceeding.
REPLACEMENT OF REMOTE CONTROL BATTERY
After a long period of use, the remote control's battery may need replacement.
The battery should be replaced when the product no longer responds to the com-
mands sent by the remote control.
The battery model to purchase is CR2025 3V.
As in the image on the right press the lever inwards on the remote control (1), and
extract the battery support by pulling it towards you (2).
After taking out the run-down battery, dispose of it in the appropriate containers
as defi ned by the regulations in your country. Replace it with a new battery of the
same model, positioning it as in the image on the right.
Re-insert the battery support with the new battery.
32
HI - HI - H2- H2- H3- H3
|||
1 Rojo / 3 seg. / 1 Rojo
Rojo
