Idiomas disponibles
Idiomas disponibles
Brand / model selection
Illustrative example for brand or model selection:
Eg: Powertech, code 1212
CODE/1
DEL/2
L1 L2
5S
Press and hold buttons 1 and 2 (CODE and DEL) for 5 seconds until LEDs L1 and L2 start flashing 2 times per second.
If the LEDs flash quickly at the same time, a transmitter has been programmed.
You will have to delete all the transmitters, see page 6 "transmitter memory reset".
You now have 5 seconds to enter the code for the mark.
Press button 1 once, then button 2, then button 1 and finally button 2.
The L1 and L2 LEDs will illuminate steady for 2 seconds, indicating that the selection has been made successfully.
If the code entered is not correct, the LEDs flash and go out.
Restart the previous procedure.
Important notes:
• This receiver supports only one brand at a time
• To change the brand we always have to reset the memory.
• When pressing the buttons if the leds flash simultaneously it means that the receiver has the permanent lock active.
to access the programming, you must enter the access pin code.
Programming transmitters in the receiver
Once you have made the brand selection you can then proceed to programme the transmitters in the receiver.
1st Channel
CODE/1
x1
Press the CODE button once, led L1 (channel 1) will flash in series of 2 flashes per second.
Press the button of the transmitter you want to programme for 1 second.
The L1 led will light up, indicating successful programming.
Repeat the process for other buttons or transmitters.
2nd Channel
CODE/1
x2
Press the CODE button twice, led L2 (channel 2) will flash in series of 2 flashes per second.
Press the button of the transmitter you want to programme for 1 second.
The L2 led will light up, indicating successful programming.
Repeat the process for other buttons or transmitters.
CODE/1
DEL/2
3
4
CODE/1
L1
1s
2x/s
L1
1s
2x/s
3
4
DEL/2
CODE/1
DEL/2
2
L1
L1
21
3
DEL/2
3
4
CODE/1
L1 L2
4
OK
NO
