Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
mNSTALLWHEEL
KIT"
3. Slide awheel over the axle.
The wheeH Haltis designed to greatly improve the portability
4.
SHidea fiat washer over the axle and pHace the e-ring
of your generator,
onto the groove in the axHe.
NOTE:_6/heeH
Haltis not intended for overothe-road
use.
5.
Place one end of the needle nose pHiers on the bottom
of the axHeand the other end of the pHiers on top of
You will need the following tools to instaHH this wheel kit:
the e-ring. Seat the e-ring by pressing the pHiers closed,
" H/2" or H 3mm socket wrench
6.
Repeat
step 3 through
5 to secure
second
wheel
" H/2" or H 3mm open end wrench
7.
Remove the temporary
bHocks.
, 7/H 6" socket wrench
8.
Attach
the vibration
mounts
to the support
Hegwith
, 7/H6" open end wrench
H/4-20 x H" capscrews and H/4-20 Hock nuts.
" Needle-nose
pliers
9. To aid support
leg assembly, rest generator
on cradle,
NOTE:
AdjustabHe wrenches
may be substituted
for open
engine end down. Remove the existing
Hod<nut from
end wrenches,
the left unit vibration
mount
with
13mm wrench.
Use
Refer
to Figure
2, and install
the wheel
kit as follows:
the same Hod<nut to attach
the support
Heg.
H.
Race the bottom
of the generator
frame on a fiat, even
H0. Attach
the other
side of the support
Hegwith a P18 x
surface.TemporariHy
place unit on blocks to ease assembly.
20 mm capscrew
and H8 lock nut. Rest generator
on
wheeHs and support
Heg.
2.
SHide axle through
both axle mounting
brackets
on
HH. Check each fastener
to ensure
it is secure.
cradHe frame, as shown
in Figure 2.
Wheel
Use existing
hardware
to attach
Heft side of
support
Hegto unit
Hex Nut _
Support
Vibration
Hount
\
Capscrew
Axle
Rat Washer
/
_. /
E-Ring
Capscrew
--
- Hex Nut
