Idiomas disponibles
Idiomas disponibles
INSTALLATION PROCEDURE / STEP 4
INSTALL LEFT BACK WALL PANEL
4
Important Note: Failure to install the back wall panels in the correct order may cause the pattern
across the back wall not to appear continuous.
Important Note: The arrows on the label on the back of each panel indicate the TOP of the Panel.
Note: Your kit contains 3 back wall panels (labeled on the back as (1) Left Back Panel (2) Center
Back Panel (3) Right Back Panel and two end panels (labeled (4) Left Side Panel & (5) Right Side
Panel).
1. Locate the panel labeled (1) Left Back Panel and lay it down on a flat surface.
2. Based on your measurements from Step 1 (Measuring) cut the panel to the appropriate size and
make any required plumbing cut-outs according to the instructions in Step 2 (Cutting).
3. Apply the double-sided tape and construction adhesive as explained in Step 3.
4. Peel o back of double-sided tape from the back of the panel. Position the panel at approxi-
mately 30 degrees, push the cut edge into the corner and then carefully push the panel towards
the back wall.
5. Push panel firmly against the wall smoothing out any air bubbles along the entire area and then
lightly tap on wall panel with a rubber mallet from top to bottom to ensure it is tightly connected
to the wall.
1
- 7 -
