Camp4 GOURMET 70677 Manual Del Usuario página 7

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
- Keep young children away from the appliance.
CAMP4 l Gas Stove Gourmet Double | 70677
SAFETY INFORMATION
Check that seals (between the appliance and the gas cartridge) are in place and in good condition before
IMPORTANT
connecting the gas cartridge (fig.6).
• Read these instructions for use carefully so as to familiarize yourself with the appliance before connecting it to
Don't use the appliance if it has damaged or worn seals.
its gas cartridge.
• Keep these instruction for future reference.
- Do not use an appliance which is leaking, damaged or which is leaking, damaged or which does not
• This appliance shall only be used with CRV butane cartridge. It may be hazardous to attempt to fit other types of
operate properly.
gas containers.
- The appliance shall be operated on a horizontal surface non likely to impair its operation (free from dry
• Don't use appliances when ambient temperature is higher than 35°C.
grass, sand, etc.).
• Don't use appliances when the cover of cartridge enclosure is in open position.
• Release or disconnect the gas cartridge after every use.
- The appliance shall be used away from flammable materials and at least 40cm away from adjacent walls
• This appliance should only be used outdoor, away from inflammable materials.
and 120cm away from ceiling.
• Keep young children away from the appliance.
- Gas cartridge shall be changed in a well-ventilated location, preferably outside, away from any sources of
WARNING
ignition, such as naked flames, pilots, electric fires and away from other people.
Check that seals (between the appliance and the gas cartridge) are in place and in good condition before
- If there is a leak on your appliance (smell of gas), take it outside immediately into a well-ventilated flame
connecting the gas cartridge (fig.6).
free location where the leak can be detected and stopped.
Don't use the appliance if it has damaged or worn seals.
- If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks using a flame, use
SAFETY DEVICE
soapy water.
• The appliance is equipped with a safety device which stops the flow of gas if the pressure in the cartridge, e.g.
- In case the pressure sensitive safety device triggers it means that a critical pressure level is reached in the
because of overheating, becomes too high.
cartridge so the appliance must not be used before it has completely cool down. Do not bypass the pressure
sensitive safety device.
USING THE STOVE FOR THE FIRST TIME
1. Check that the control knob (8) is set to position "•" by turning it clockwise and the cartridge lever (6) is set to
SAFETY DEVICE
UNLOCK.
2. Open the cartridge cover (2) and insert the cartridge, with the head to the front, so the notch points upwards
- The appliance is equipped with a safety device which stops the flow of gas if the pressure in the
and aligns in the value guide (fig.2).
cartridge, e.g. because of overheating, becomes too high.
3. Press the cartridge lever (6) down (fig.3) and close the cartridge cover.
To continue usage...
4. If you hear a "hissing" noise, the cartridge has not been correctly fitted.
Do not attempt to ignite the appliance but move lever (6) to the "Unlock"
- Turn the control knob to "●" position.
position and repeat step (1-4).
- Turn the cartridge lever to "UNLOCK" position and take the cartridge out.
5. Press the gas flow lever (fig.4) down to release the gas.
6. Turn the knob (8) fully to the ignition position until it clicks. (fig.4) Repeat
- Turn the control knob to the ignition position to release any excess pressure
this action until burner ignites.
inside the valve.
7. Adjust the control knob to the required position (fig.5) Never set the
- Push down the reset lever with red rubber cap.
cartridge lever (6) to the "UNLOCK" position during use!
To continue usage:
- Place new cartridge after checking that the cartridge lever is in "UNLOCK"
• Turn the control knob to "•" position.
position. ( If new cartridge is not hand, cool down the cartridge in use with water. )
• Turn the cartridge lever to "UNLOCK" position and take the cartridge out.
- The cartridge can only be installed when the control knob is in the OFF-position.
• Turn the control knob to the ignition position to release any excess
pressure inside the valve.
• Push down the reset lever with red rubber cap.
• Place new cartridge after checking that the cartridge lever is in "UNLOCK" position.
• The cartridge can only be installed when the control knob is in the OFF-position.
AFTER USE
1. Turn the control knob (8) into the "•" position.
2. Check if burner is extinguished before setting the cartridge lever (6) to the "UNLOCK" position.
3. When the appliance has cooled completely, for your own safety, remove the cartridge.
4. Fit red protective cap and always store the gas cartridge in a cool, dry, well ventilated place.
7
Reset lever
Reset lever
DE
EN
IT
ES
FR
NL
FI
DK
SE
loading

Productos relacionados para Camp4 GOURMET 70677