Technical data
Description
Voltage
Speed
IP Grade
Size of threaded thread
Battery
Charger
WARNING
If the power cable is damaged, it must be replaced by the manufacturer or a
Center to prevent any risk of electric shock or significant accident.
The electrical insulation of this tool is compromised by splashes or spillage of liquids during its operation.
Do not expose it to rain, liquids, and/or moisture.
Before accessing the terminals, all power circuits must be disconnected.
WARNING
Power Requirements
WARNING
Tools with double insulation and reinforced insulation are
equipped with a polarized plug (one prong is wider than the other). This plug will
only fit in the right way into a polarized outlet. If the plug cannot be introduced into
the outlet, reverse the plug. If it still doesn't fit, call a qualified electrician to install
for you a polarized outlet. Do not alter the plug in any way. Both insulation types
eliminate the need of both a grounded third power cord with three prongs or a
grounded power connection.
WARNING
When using an extension cable, verify the gauge is enough for
the power that your product needs. A lower gauge cable will cause voltage drop in the line, resulting in power loss and
overheating. The following table shows the right size to use depending on cable's length and the ampere capability shown in
the tool's nameplate. When in doubt use the next higher gauge.
Capacity in
Amperes
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
When operating electric tools outdoors, use a grounded extension cord
WARNING
marked as
outdoor use and reduce the risk of electric shock.
Code
Discs
Ion-lithium 20 V
Input:
The construction class of the charger is: Reinforced insulation.
Number of
Conductors
3 (one grounded)
* It is allowed to use it if the extensions themselves have an overcurrent protection device.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE.
'Outdoor Use'. These extensions are specially designed for
ESMI-20P
28267
Cordless angle grinder
4 1/2"
20 V
7 100 RPM
IP40
5/8 - 11 - UNC - 1A
4 Ah
Charging time: 117 min approx
Voltage:
127 V
Ouput:
Fequency:
60 Hz
Voltage:
Current:
0.9 A
Current:
The power cable has Y-type cable holders.
The tool's construction class is Class III.
Extension gauge
from 1.8 m to 15 m
18 AWG( * )
16 AWG
14 AWG
8 AWG
21 V
2.5 A
Service
higher than 15 m
16 AWG
14 AWG
12 AWG
6 AWG
3
ENGLISH
