Installation - BWT Infinity A+AP Instrucciones De Montaje Y De Servicio

EN
0 0 0
Σ m
3
1.
3.
> 400 mm
26
2.
4.
5
6
> 20 mm
> 1 m
9

Installation

Caution! Do not plug in the power supply unit (3)
until startup.
Install the filter in the cold water pipes upstream
of the objects to be protected (see installation
diagram). Always provide stop valves.
Install the connecting module or connector in the
direction of flow in a horizontal or vertical cold water
pipe (observe direction of flow arrow).
Connection to connecting module
3/4" - 1 1/4"
1. Turn the black retaining ring to the left limit stop.
2. Press the prongs of the device into the spaces
provided
3. Rotate the device clockwise 45° to the limit
stop.
4. Pull the black retaining ring with both hands
towards the device until it clicks into place. The
device cannot now be rotated unintentionally.
To release the filter, press the retaining ring
towards the connecting module.
Connecting to connector
1 1/2" and 2"
1. Screw the filter to the connector using 4 hexa-
gon screws and the seal (screws and washers
included).
2. Check the seal for proper fit. Tighten the screws
evenly and crosswise.
Wastewater connection
Route the wastewater connection to the drain so
that no reflux occurs.
Note: Do not bend the vent tube (5) when changing
to the hose connection (6).
Note: The flushing water hose must be secured at
a distance of at least 20 mm from the highest
possible waste water level (free discharge).