Safety Instructions; General Safety Instructions; Product-Specific Safety Instructions; Personnel Qualifications - BWT Infinity A+AP Instrucciones De Montaje Y De Servicio

2

Safety Instructions

The product was manufactured according to all
recognised regulations and technical standards and
was in compliance with the relevant legal require-
ments when it was put into circulation. Neverthel-
ess, it can pose a risk of personal injury or property
damage if you do not observe this chapter and the
safety instructions throughout this documentation.
Carry out only those activities that are described
in this operating manual, unless you have been
trained by BWT.
Carry out all activities in accordance with all appli-
cable standards and requirements.
Instruct the operator of the product on the product's
function and how to use it.
Inform the operator of the product about how to
maintain the product.
Inform the operator of the product about the
possible hazards that may arise when operating
the product.
2.1

General safety instructions

Read this documentation carefully and in its entirety
before working with the product.
Store this documentation so that it is accessible to
all users at all times.
Include the complete documentation if you transfer
the product to a third party.
Follow all instructions regarding proper use of the
product.
If you notice damage to the product or the mains
supply line, cease operation immediately and in-
form the service personnel.
Use only accessories, spare parts and consumab-
les that have been approved by BWT.
Adhere to the environmental and operating con-
ditions specified in the "Technical Data" section.
Wear personal protective equipment. This equip-
ment is for your own safety and will protect you
from injury.
2.2 Product­specific safety instructions
In the following sections, you will find product-
specific safety instructions whenever you must per-
form certain safety-relevant actions on the device.
2.3

Personnel qualifications

The installation activities described in this manual
require basic knowledge of mechanics, hydraulics
and electrical systems as well as knowledge of the
technical terminology associated with those fields.
To ensure safe installation, these activities may only
be carried out by a specialist or by a trained person
who is under the direction of a specialist.
A specialist is defined as someone who has the
technical training, knowledge and experience as
well as the knowledge of applicable regulations
required to properly assess the work assigned to
him/her, identify possible hazards and take approp-
riate safety measures. Specialists must comply with
applicable, industry-specific regulations.
3

Transport, Installation

Transport the system as a complete unit, if possible.
If you must dismantle the system before transport,
check that all individual parts are present.
If there is a risk of frost, drain all components that
convey water.
Lift or transport the system or system components
only from the intended suspension eyes or attach-
ment points.
The system must be placed on a horizontal surface
or mounted to a vertical surface that is sufficiently
flat and has a sufficient load-bearing capacity. It
must be secured so that it does not fall or tip over.
EN
21
21