Idiomas disponibles
Idiomas disponibles
iSENSE TRACK ARC
8.3.3 Sensor status LED
1. Laser warning
2. Ethernet status LED The Ethernet status LED illuminates after approx. 3 s. It usually flashes several
3. Sensor status LED
The table below indicates the meaning of the individual colors or color combinations for the sensor status
LED. The colors used can vary depending on the different uses of the sensor head.
► Check the system-specific documentation for potential differences.
Status
Illuminates
Illuminates blue
Illuminates red
Illuminates
magenta
Illuminates green
Flashes green
Flashes magenta
Flashes blue
8.4 Configuring system and seam settings
iSENSE TRACK ARC software operating instructions (included)
9 Decommissioning
Disconnect the device from the power supply.
1
Disconnect all media supplies.
2
Disconnect all electrical connections.
3
If the breakout board is supplied with power, the laser warning LEDs illuminate
LEDs
providing the laser is activated. If the laser safety circuit deactivates the laser, the
laser warning LEDs briefly flash (as part of a check that they are working
correctly) and then remain off.
times while the Ethernet network determines which other devices are connected
to the network.
The sensor status LED illuminates after approx. 5 s. It illuminates green for
approx. 0.5 s and then blue. The sensor is now switched on and ready for use.
Meaning
Sensor head not switched on or sensor software not booted up.
Sensor OK, ready for operation.
Hardware fault/fault with the image analysis.
Sensor OK but getting hot.
► Check the cooling system.
Sensor tracking.
Sensor sending measurement data (via Ethernet).
Sensor sending measurement data (via Ethernet) but sensor head getting hot.
► Check the cooling system.
Sensor head loading/saving setup data in the internal memory.
The color of the sensor status LED changes based on the
current status of the sensor head. It cannot only change
color, but also flash in two different colors. The sensor is
usually part of another machine, which therefore controls
it. If the sensor head is supplied with power, the LEDs
respond as follows:
9 Decommissioning
EN - 21
