Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing the Antenna
■ Installation Precedure
1.
Confirm the installation place.
• Affix the film antennas and cable
connectors to the front windshield
following the laws and regulations of
your country.
• Affix each film antenna so that it does
not overlap the ceramic line. Affixing
the antenna on the ceramic line will
lose the adhesion force.
2.
Using the cleaner (Accessory
0), wipe dirt off the antenna
installation surface.
3.
Affix each film antenna.
1) Peel off the release paper (half-
transparent sheet) 1 starting at the
slit, and then affix the film antenna to
the windshield.
• Once peeled off, the remaining
portions of the antenna cannot be
affixed again. Confirm the installation
place again.
2) Peel off the release paper 2 starting
at either slit, and affix the film
antenna to the windshield.
3) Peel off the release paper 3 and
release paper 4 and affix the film
antenna to the windshield in the
same manner as above.
• Either the left or right side of the film
antenna can be affixed first.
• Inserting the release paper 1 under
the corner of the film antenna as
shown on the right allows you to
peel off other sheets of release paper
easily.
6
|
English
Ceramic line
Film antenna
Cable connector
4
Slit
3
Viewed from inside the vehicle
Slit
1
2
3
Film antenna
(Accessory 1)
Slit
Release paper 1
4
Tabla de contenido
