Carat 1900 Instrucciones página 8

ELECTRIC MIXER 1900
1. TECHNICAL DATA
Model: Carat mixer 1900
Power: 1900W
No-laad speed:
1 Gear: 150 - 300 rpm
st
2 Gear: 300 - 650 rpm
nd
Diameter mixing rod: 160 mm
Protection class: II
Vibration value: 2,423m/s2 K=1,5m/s2
2. CONTROL ELEMENTS
3
5
2
1 Switch/regulator
2 Arresting pin
3 Ventilation holes
4 Tool mount
5 Speed selecter switch
6 Supplementary handle
7 Flat open-end wrench
8 Whisk
Not all of the accessories illustrated or described are
included as standard.
3. SAFETY PRECAUTIONS
Safe work with the instrument is only possible
aft er you read thoroughly this manual for use and
maintenance and observe precisely the here specified
instructions. Observe also other safety directions
that are a part of each instrument delivery.
• Check the flexible lead and plug before each use of the
instrument. Have the faults removed by an expert.
8
1
4
8
• The instrument should not be operated in damp, wet
premlses; during a rain, fog and snow in the open, and in
environment wlth a risk of explosion.
• Before putting the plug in the mains socket the switch
should be in the "off " position.
• Take care of long hair and fashion accessories; work in
properly buttoned-up clothes, without freely flowing
parts.
• Secure the vessel with the mixed substance against
moving on the floor.
• Always direct backwards the flexible lead from the
instrument, flexible lead should not be exerted by tensîle
stress and should not lie on or pass over sharp edges.
• Take care that you take a safe and firm stand at work.
• Use the supplementary handle.
• Consider possible reaction torque.
4. STARTING OPERATION AND USE
lmproper use may damage the instrument.
Observe therefore these instructions:
• Use a tool up to the specified diameter.
• Load the instrument in such a way that the speed would
not drop considerably or that it would stop.
Check if the data on the rating plate correspond with the
actual mains voltage. Instrument scheduled for 110V/230V
can be plugged to 110V/220V/240V mains.
Flixing a whist
Screw toots with thread M14 x 2 as far as possible In
the tool mount and tighten properly with an open-end
wrench (22 mm) from among the accessories.
Switching on and off
By pressing the switch button the apparatus is brought
into operation and it stops when it is relieved.
Permanent run
By pressing the switch button to the stop and simultane-
ous pressing the arresting pin permanent run Is achieved.
By subsequent pressing and relieving of the switch button
the permanent run is interrupted.
Unloading the tool (whisk)
Fit a flat open-end wrench (22 mm) on the hexagon end of
the tool (whisk) and unscrew the tool from the spindle by
tuming it to the left .