Idiomas disponibles
Idiomas disponibles
Yourcleaning system requires someassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withtherecommended oilandfuel.
If you haveanyproblemswith the assemblyof
your pressurewasher,pleasecallthe pressure
washerhelplineat 1-800-222-3136.
IMPORTANT: Anyattempt t o runthe engine before it
hasbeenserviced withthe recommended oilwill result
inanengine failure.
REMOVE
PRESSURE
WASHER
FROM CARTON
•
Open carton and slice two corners opposite guide
handle from top to bottom so the panel can be
folded down flat.
•
Remove hose reel box, fillers, and parts box
shipped with your cleaning system.
•
Roll the cleaning system out the open end of the
carton.
•
Raise guide handle, secure in place.
Lift the handle to upright
position and slide the locking
caps into place
•
Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
•
Main unit--
cleaning system with wheels, chemical
tanks, guide handle
•
Hose reel components
•
High pressure hose
•
Parts box (which includes items listed below)
Spray gun
Nozzle extension with adjustable nozzle
Engine oil
Three-pack of chemical concentrates
Owner's manual
Nozzle cleaning kit
"O"-ring kit
Tank labels
Quick connect fitting
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 7. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING
YOUR CLEANING
SYSTEM
Your Craftsman high pressure cleaning system was
mostly assembled at the factory. However, you will
need to perform these tasks before you can operate
your cleaning system:
•
Attach hose reel.
•
Add oil to engine crankcase.
•
Add fuel to fuel tank.
•
Connect high pressure hose to the spray gun and
pump.
•
Connect water supply to pump.
Assembling
Hose Reel
IMPORTANT:
You must take the hose off the reel
when operating your high pressure washer. The reel is
for storage purposes only.
•
Attach the handle to the reel with Iocknuts,
flatwashers, and bolts as shown.
•
Secure the hose reel to the left side upright, (from
behind the unit), with Iocknuts, flatwashers, and
bolts. See page 7 for reel mounting location.
M6
,_
M6 Flatwashers
Handle
/
M6 Locknuts
M6 Flatwashers
M8 Bolts
/
M8 Locknuts
M8 Flatwashers
