Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING:
from the power source before adjusting, adding accessories, or checking a
function on the tool.
Installing or replacing Sanding Disc and
Guard (FIG 3)
One 6" sanding disc (3) and the disc guard (1) are pre-
installed at the factory.
To replace the sanding disc
1. Unplug the sander from the power source.
2. Using a Phillips screwdriver, loosen and remove two
screws (2) on the disc guard.
3. Remove the disc guard.
4. Peel off the old sanding disc.
5. Remove the backing from a new sanding disc. Align
perimeter of disc with sanding plate and firmly press the
disc into position.
6. Reinstall the disc guard as shown on FIG 3. The disc
guard can be adjusted up and down to cover sanding
disc for more protection.
Installing or Replacing Sanding Belt
(FIG 4, 5, 6)
A sanding belt is pre-installed and aligned at the factory.
To replace the sanding belt
NOTE:
Use 4"x36" (100mm x 914mm) sanding
belt. On the smooth side of the sanding belt,
there is a directional arrow. The sanding belt
must run in the direction of the arrow.
1. Unplug the sander from the power source.
2. Pull the Belt Tension Lever (1) at direction shown on FIG
4 to release belt tension.
3. Loosen and remove the screw (3) on each side of belt
bed (8). Remove the upper belt guard (5).
4. Loosen and remove two screws (4) on each side of belt
bed (8). Remove the lower belt guard (7).
5. Remove the rubber bump (6).
6. Remove the old sanding belt (10) from driver (9) and idler
rollers (10). See FIG 6.
7. Place a new sanding belt over the driver roller (9) and
idler roller (10) with the direction arrows running
counter-clockwise. Be sure the sanding belt is centered
on both rollers.
8. Put rubber bump, lower belt guard and upper belt guard
back on. Tighten screws (3, 4) on both sides of the belt
bed (8) to keep guards (5, 7) in place.
9. Push the belt tension lever (1) back into locking position
to apply belt tension.
Always be sure that the tool is switched off and unplugged
3
2
2
1
FIG 4
4
3
5
FIG 6
11
9
1
FIG 3
FIG 5
8
6
7
10
9
Tabla de contenido
