WolfPack KWAG1801 Manual De Instrucciones página 36

12. TECHNICAL DETAILS
Model
No-Load Speed
Voltage
Charger
Cutting disc Ø
Bore Ø
Charging time
13. NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
aw (Vibration)
13.1 NOISE AND VIBRATION INFORMATION
The vibration emission level given in this information sheet has been measured in
accordance with a standardised test and may be used to compare one tool with another.
The given vibration emission level may be used for the initial estimation of the real exposure.
The vibration emission level will vary because of the ways in which a power tool can be used
and may increase above the level given in this information sheet
ATTENTION! Wear hearing protection when the sound pressure is
over 85 dB(A).
14. ENVIRONMENT
Electrical and electronic equipment must not be disposed of with household waste. In
accordance with the European standard 2012/19/EU for the disposal of electrical
equipment (WEEE), it must be taken to the local waste collection plant for recycling.
Used batteries must not be disposed of with household waste. According to the
battery regulations, you are obliged to deposit used or defective batteries at local
collection points or shops. In case of non-compliance, it will be sanctioned with a fine.
Li-Ion
Be sure to wear safety goggles, dust masks and ear
protection during use!
826 dB(A)
93,6 dB(A)
3.257 m/s K = 1,5 m/s
2
Pri: 100-240 V~/ 50-60 Hz
Sec: 21,5 V
2
36
KWAG1801
7.500 min-1
20 V
/ 1,5 A
115 mm
M14
3 hours