Idiomas disponibles
Idiomas disponibles
1. Position the pasture fencer so that the panel points south.
This positioning enables the panel to absorb a maximum amount of sunlight
even during the few light winter days When placing the energizer, consider
the position of the sun throughout the day and avoid a location which could
cover the energizer with shade from trees, bushes or high grass.
2. Determine the correct angle of inclination for the solar panel.
The position of the sun above the horizon changes during the seasons. As
a general recommendation, an angle of 50 degrees is optimal for long-term
use in most parts of Europe. Nevertheless, the angle can be adjusted condi-
tional upon the season to optimize the output of the solar panel for recharg-
ing the rechargeable battery (see Fig. below). The steeper the angle of
inclination, the greater the cleaning effect during rain or snow.
Recommended setting angle of the panel
South Europe / North Africa (South CH & A)
50°
Winter
Spring
Nov. - Feb.
Mar. & Apr.
Fall
Sept. & Oct.
It may be the case that in winter (except for southern Europe) there are not
enough hours of sunshine to fully charge the rechargeable battery.
3. Regularly remove any deposits and dirt from the solar panel
This includes removing cut grass, dust (specifically along gravel paths),
leaves and snow, since these can reduce the performance of the module for
recharging the rechargeable battery.
Only check the rechargeable battery indicator in solar operation at dawn
(without sunlight).
SAFETY INSTRUCTIONS FOR CLEANING SOLAR MODULES
- Check the electrical connections before cleaning. Defective connections can cause short circuits.
- T he modules should be cleaned before they reach working temperature, i.e. early in the morning. In addition they should
only be cleaned with water at ambient temperature in order to avoid thermal stresses.
- D o not clean the modules if they are too hot and/or exposed to strong sunlight. The shock of cold water on a hot module
can damage solar cells.
CLEANING INSTRUCTIONS
- M ake sure that the water used is free of particles and foreign bodies that could damage the module surface.
- Ensure that the glass surface is not scratched or damaged or that any foreign bodies are applied to it.
- T he use of pressure or steam cleaners, acetone, high-pressure cleaners, knives, blades and metal-containing sponges is
not permitted for modules and will invalidate the manufacturer's warranty.
- Avoid exerting pressure on the module surface when drying.
4
43°
Summer
May & Aug.
Empfohlener Anstellwinkel des Panels
Nord- & Mitteleuropa (einschließlich A & CH)
60°
50°
Winter
Frühjahr
Nov. - Feb.
Mär. & Apr.
Herbst
Sep. & Okt.
Sommer
Mai & Aug.
