Equipment Controls; A) Control Panel Pictograms - Walter Surface Technologies SURFOX 205 Manual De Usario

Ocultar thumbs

página de 82

/ 82
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Safety instructions

Voltage/Amperage

Before connecting this unit, check that the voltage and amper-

age shown on the rating plate is the same as the power supply.

Operating this unit other than speciﬁed on its rating plate may

result in personal injury to the user and damage the unit.

Preventive maintenance

After use, allow the cleaning accessory to cool. Remove the

cleaning pad and tungsten or the brush and the adaptor.

Neutralize with SURFOX-N and rinse with water and dry.

Clean dust and dirt deposits on the outside of the unit.

Keep air vents clean and free of any obstructions. Clean the

power cord to prevent deterioration and check for possible

damage to cord and plug.

Note: Damaged cords must be replaced immediately by

qualiﬁed personnel only. Refer to Spare Parts List for the

ordering number.

Transportation

Before transporting the machine, make sure the cleaning

solution reservoir and supply line are completely empty and

all connecting lines disconnected. The machine must be

carefully packed in a suitable container and properly

protected. WALTER will not be held responsible for any

damages resulting from leaked cleaning solution or rough

handling.

Storage

If the machine is to be stored for any length of time, the

cleaning solution reservoir and supply line must be emptied,

cleaning accessories removed, neutralized, rinsed and

dried. Store in a dry safe place to avoid damage, especially

to the electronic components.

Waste disposal

Dispose of residual waste in compliance with Federal,

Provincial, State and local environmental regulations. Refer

to WALTER Safety Data Sheet of the SURFOX electrolyte

cleaning solutions.

Extension cord

When an extension cord is needed, use wire size 14 (AWG)

for up to 50 feet (15 meters) and size 12 (AWG) for 50 to

100 feet (15 to 30 meters).