Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Neutralizing
The SURFOX-N liquid is a specially formulated neutralizer
for the SURFOX electrolyte solutions. It is a powerful
ready-to-use formula which leaves no residue, is non-toxic,
solvent free, water-based and biodegradable.
A) Directions for neutralizing SURFOX
electrolyte cleaning solutions
1. Remove any excess SURFOX electrolyte solution using
a soft cloth or rinsing with water.
2. Spray SURFOX-N on the surface.
3. Wipe dry with another soft clean water.
For more information about this product, refer to product SDS.
WARNING!
Be sure to wipe off all excess SURFOX
electrolyte solution from the surface and neutralize
otherwise the inorganic salt from the phosphoric
acid will adhere to the surface and cause deposits.
SURFOX-N neutralizer Part No.
500 ml
5 L
20 L
208 L
B) SURFOX WELD cleaning and neutralization
procedure
Clean the weld using the SURFOX machine and SURFOX
electrolyte solutions. Work only 2 feet at a time.
Note: The cleaning accessory should be kept moist – not dripping.
1. After weld cleaning, use a clean cloth or paper towel and
wipe the affected area in a squeegee action from left to
right. Then discard the cloth or paper towel. You could
also rinse the surface with water.
After cleaning the weld with the SURFOX weld cleaning
machine, the electrolyte solution must be neutralized.
1. Spray the affected area with SURFOX-N neutralizer.
Allow to sit for 15 seconds on the surface.
2. Use a clean cloth or paper towel and wipe the affected
area in a squeegee action from left to right. Then discard
the cloth or paper towel. You could also rinse the
surface with water.
Note: Failure to neutralize or neutralize properly will result in clouding,
hazing and dulling of the surface on top of slowing the passivation
process.
54-A 023
54-A 026
54-A 027
54-A 028
9
Neutralizing
Permanent salt deposits due
to unproper neutralization
and rinsing.
SURFOX 205 User's Guide
13
Capítulos
Tabla de contenido
