GreenWorks Commercial 82H26D Manual Del Operador página 7

Cortador de setos
Idiomas disponibles

Idiomas disponibles

3. Remove the machine from the box.
4. Discard the box and package in compliance with local
regulations.
8.1.1
INSTALL THE BLADE ASSEMBLY
1. Put the machine on a flat and smooth surface.
2. Slide the blade assembly (15) into the rotating shaft (17).
3. Insert the bolts and tighten with a screwdriver (not
included).
8.1.2
CONNECT THE BATTERY PACK TO
THE MACHINE
1. Insert the plug (11) of one side of the cable into the
socket (12) in the machine – line up the lugs on the plug
with the slots in the socket.
2. Push the plug into the socket until it stops, then turn it
clockwise until the plug's latch engages audibly.
3. Insert the plug (13) of the other side of the cable into the
socket (14) in the battery – line up the lugs on the plug
with the slots in the socket.
English
4. Push the plug into the socket until it stops, then turn it
clockwise until the plug's latch engages audibly.
9
OPERATION
Touch the blade carefully.
Do not put your fingers into the notches or in position
where they can get cut.
Do not touch the blade unless you remove the battery
pack.
Do not use the machine if the blade is damaged or bent.
Remove all objects such as cords, lights, wire, or string
which can become entangled in the cutting blade and
create a risk of personal injury.
If the blade jams on an electrical cord or line, DO NOT
TOUCH THE BLADE! IT CAN BE LIVE AND
DANGEROUS. Do the steps below:
1. Hold the insulated rear handle or put the machine down
and away from you.
2. Disconnect the electrically service to the damaged line
or cord before you try to free the blade.
9.1
START THE MACHINE
2
1. Press the power button (9).
2. Push and hold the micro switch (8) with one hand.
3. Push the trigger (2).
Hold the machine with hands during operation.
If the machine accidentally falls,it will stop and the blade
will fully stop after a few seconds. The machine will then
locks OFF.
7
WARNING
9
8
WARNING
NOTE
EN
loading

Este manual también es adecuado para:

Htb441