Idiomas disponibles
Idiomas disponibles
Preparation of the surfaces
Before putting the machine into operation, carefully remove the corrosion protection or grease
residues from the bare metal parts. This can be done with the usual solvents. Under no
circumstances should you use nitro thinners or other cleaning agents, as these can attack the
machine´s finish.
The use of paint thinners, petro, aggressive chemicals or scouring agents will damage
the surfaces!
Therefore: Use only mild cleaning agents!
14.2
Assemble
The machine and machine parts are heavy!
At least 2 people are required to set up the machine.
The machine has been disassembled for transport and must be reassembled before use.
HOLZMANN Maschinen GmbH
-
-
-
-
Table settings:
-
-
-
www.holzmann-maschinen.at
N O TE
N O TE
1.
Sliding table
- Place the sliding table (1) on the machine and fix
it at the fixing points (2) using the before
removed screws, spring washers and washers (3).
Do not tighten the screws before adjusting of the
sliding table is finished.
- Level the edge of the sliding table with that of
the work table (using a spirit level) until it is
horizontally aligned without gaps.
NOTE:
Over the entire length, the distance between
the two table edges must be within 12mm.
Furthermore, it should be aligned exactly to the rip
fence / saw blade.
- Then tighten the screws and insert the cover
caps (4) into the mounting holes.
2.
Table extension / table widening
Remove the screws, spring washers and washers
(1) from the threads (2) in the worktable
Position the table extension (3) and table
widening (3a) on the worktable as shown
Fix screws, spring washers and washers
Check alignment and adjust table if necessary
Loosen the screws (1) slightly
Adjust and fix plane and horizontal alignment
with set screws (4)
Tighten the screws firmly.
ASSEMBLY
39
FKS305V32TOP_400V
