posits of liquids (e.g. sinks, etc.) to avoid falling into or splashing with water (minimum
distance 2 met re s) fabrics (curtains, etc.) or loose materials, which may obstruct the ven-
tilation grille; in addition, check that the front part is free of volatile materials (dust, etc.).
• The supporting surface must be stable flat and even (so that the appliance does not tip
over).
ASSEMBLY
1. Insert the pipe (10) into the base (11) and lock them together by tightening the loc-
king screw (12).
2. Install the rear guard and then lock it by turning the rear guard nut (4) clockwise.
3. Insert the blade (3) into the motor shaft and fix it by tightening the blade fixing nut
(2) counterclockwise.
4. Put the front guard (1) and rear guard (5) together and then fix them with fixing
buckles and safety screw sets (13, 14) provided.
USE
a) Ensure voltage used corresponds with the voltage indicated.
b) Turn the speed control on the tube to selected speeds: 0 refers to Off. Speeds 1, 2, 3
refer to Slow, Middle, and Fast respectively.
c) Push down the oscillation switch (7), and the fan head rotates. Pull up the oscillation
switch (7), and the fan head stops rotating.
d) The direction of the air flow is vertically adjusted by tilting the fan head.
e) Never touch the blades with hand or any object!
f) Do not pull the cord too hard. If damaged after prolonged use, get it repaired by a
qualified electrician.
g) To clean: Disconnect the power cord from the mains. Remove the guard and the bla-
des carefully. Do not drop the blades! First use soft cloth with light soap to clean off oil
stains. Then wipe and dry with dry cloth. Never use polish or any corrosive liquid that
will damage the paint, metal or plastic! Put back the blades and lock the guard securely
before use.
NO exchange claims will be accepted if the above instructions are not followed. Always
test the product first before purchase.
CLEANING AND MAINTENANCE
Warning: before carrying out the normal cleaning operations, remove the plug from
the mains sock- et.
• To clean the appliance, use a soft, slightly damp cloth; do not use abrasive or corrosive
products.
• Do not immerse any part of the fan in water or any other liquid: if this happens, do
not immerse your hand in the liquid and, first of all, remove the plug from the mains
socketi Dry the appliance carefully and check that all the electrical parts are not wet: if
in doubt, contact a qualified technician.
• It is essential to keep the ventilation holes of the motor free of dust and fluff.
• In case of long periods of non-use store the fan, protecting it from dust and moisture;
we recommend using the original packaging.
• If you decide to stop using the appliance, it is advisable to render it inoperational by
cutting the power cable (first ensuring that the plug has been disconnected from the
13