Idiomas disponibles
Idiomas disponibles
• Do not coil the power cable around or on top of the product while it is working.
• If the cable gets damaged it must be replaced by S&P – take the equipment to our offi cial S&P
because the work must be done by specialist personnel to avoid any risk of damage.
EN
• The heater must always work vertically, with the controls at the top and the base located on a
stable surface.
• Only for internal use.
• Do not use this heater in the immediate vicinity of a bathtub, shower or swimming pool.
• Do not use this heater if it has been dropped.
• Do not use if there are visible signs of damage to the heater.
• Use this heating appliance on a horizontal and stable surface, or if possible fi x it to a wall.
• WARNING: Do not use this heater in rooms that are occupied by persons who cannot leave the
room by themselves, unless permanent surveillance is provided.
• WARNING: To reduce the risk of fi re, keep textiles, curtains, or other fl ammable material at
least 1m away from the air outlet.
2. THE PRODUCT
Description of the product (Figure 1):
A
Outlet air
B
Thermostat
C
Power selector
D
LED
E
Transport handle
F
Inlet air
G
Safety tilt switch
3. USE AND OPERATION
• Before connecting the product to the power, make sure that it is located on a stable fl oor and has a fi rm vertical position.
Remember that as a safety feature, the product incorporates a safety tilt switch under the base (Fig.1 G)
• Connect the plug into the power point. The heater is a Class II appliance and it does not require an earth connection.
• Select the required power using the power selector and move the thermostat control to maximum position.
− Power selector (Fig.1C).
O
Stop
Fan (cold air)
I
Hot air heater (800W)
Very hot air heater (1800W)
II
− Thermostat (Fig.1B)
Min.
Once the room has reached the desired temperature, slowly move the control until there is a soft "click" and the device
is disconnected. From this time the heater turns on and off automatically, keeping the pre-selected comfort tempera-
ture.
Note: The LED is illuminated whenever the heater is operating.
• Anti frost device
This device is especially useful in places where low temperatures are reached and there is a risk of water freezing in
internal water pipes. The heater will automatically maintain the temperature of the room at about +5ºC when left on this
setting.
8
Max.
