Connection For Tig - Furius FIX 205CEL Manual De Usuario

Connection for TIG

Duty cycle excess protection or thermal control device.
When there is protection by reaching the maximum duty cycle, or by internal heating of the machine, the arc is
extinguished and the protection of the machine is activated, while the welder cools down to continue its normal
operation. Do not turn o the welder, allow the fans of the equipment to cool the machine's power components until
the machine protection deactivates. Only until this moment can the machine be switched o or start welding again.
Note: to preserve the power components of the welding machine from heat accumulation, do not disconnect it
immediately after activation of the protection, as described above.
Connection for TIG
To use TIG with the Furius FIX 201 connect the torch to the negative socket or connector of the machine and the work
clamp (ground) to the positive socket or connector of the machine, as shown in the following gure:
14
YEAR
WARRANTY