Assembly And Initial Use; Power Switch; Transport Strap - Furius FIX 205CEL Manual De Usuario

Assembly and initial use

Assembly and initial use
Note: It is necessary to use an electrode holder that complies with the NMX-J-038/11-ANCE standard. Use a helmet in
accordance with regulations and that has protective glasses in accordance with regulations, the level of protection
(shade) must be at least 9-10. There should be a slag hammer and wire brush. Before assembling make sure that the
power switch is turned o and that the power socket of the equipment is disconnected.
Connect the work cable to the ground socket with the negative (-) symbol (MMA)
Connect the torch to the ground socket with the negative symbol (-) (TIG)
Insert the coupling into the socket, and then turn it clockwise until it clicks. Pull on the coupling device to ensure it is
properly coupled. These coupling devices must be clean and free of oil.
Connect the electrode cable to the socket with the positive symbol (+). (MMA)
Connect work cable to socket with positive (+) symbol. (TIG)
Insert the coupling into the socket marked positive (+), and then turn it clockwise. Pull on the coupling device to verify
that it is properly coupled. These coupling devices must be clean and free of oil.

Power switch

This switch allows you to turn the equipment on and o with an audible click.

Transport Strap

Use it to transport the equipment easily and safely. The installation of the transport strap is carried out in the slits in the
upper part of the plastic housings of the equipment.
Operation
Environment conditions
a) Operating ambient temperature: −10 ℃ 〜 ＋ 40 ℃, Transport and storage temperature: −20 ℃ 〜 ＋ 55 ℃.
b) Relative humidity: Up to 50% at 40 ℃ and up to 90% at 20 ℃.
c) Operating environment with normal levels of dust, acid, corrosive gases that are not di erent from those produced by
the welding process and that allow adequate ventilation.
11
YEAR
WARRANTY