Idiomas disponibles
Idiomas disponibles
To enhance the appearance
and maintain performance,
the refrigerator
should be leveled per instructions
below.
To protect p_perty
and refrigerotor
from
damage,
obsen_e the following:
. Protect vinyl or otl_er flooring
with ca_board
rugs,
or other protective
material.
• Do not use power tools when peiforming
leve!ing
procedure.
Notes:
. Complete any required door reversal, panel
installation
and/or a water supply connection
before leveling.
, Some models only have adjustment
screws (A).
Materials
Needed:
- _," hex head driver
• Carpentees
level
]. Remove toe grille.
. Grasp firmly and pull
outward to unclip.
2. Using hex head driver, turn the
front adjustment
screws (A) on each side to raise
or lower the front of the refrigerator
(see
illustration
beiow)_
,
4,
5_
Using the hex head drivec turn each of tl_ese
adjustment
screws (B) to raise or lower the rear of
the refrigerator.
Using a carpenter's
level, make sure front of
refrigerator
is ;_" 1_6 ram) or approximately
}J_ bubble
higher than hack of refrigerator
and that the
level from side to side.
Turn stabilizing
legs (C) ctockwt:se untif firmly
against floor,
6. Turn adjustment
screws (A) counterclockwise
until
the full weight of the refrigerator
rests on the
stabilizing
legs.
7. Replace the toe grille,
• Align the toe grille mounting
clips with the lower
cabinet stots.
, Push the toe grille finely until it snaps into place.
Door and Drawer Removal
Some installations
require door!drawer
removal to
transport
the refrigerator
to its final location,
To avoid
electrical
shock which can cause
severe personal
inju_
or death,
observe the
followiag:
, Disconnect
power to refrigerator
befot_ removing
doors or drawer. Connect power only after
replacing doors or drawer.
To avoid damage to walls and flooring, protect vinyl
or other flooring with cardboard,
rugs or other
protective
material.
Materials
Needed:
- },4_," hex head driver
. Phitiips screwdriver
. _" hex head driver
1_ Unplug power co_:d from power source.
2. Remove toe grille.
3. Remove top hinge cover from
refrigerator
door by removing Phillips
screw and retain screw and cover for
later use_
4. Unscrew '_1/' hex head screws from
top hinge to remove Mnge and
retain all screws for later use.
5_
Lift refrigerator
door from
center Mnge pin, Remove door
closure from center hinge pin on tile
rigtlt side and f_tain for later use.
