Idiomas disponibles
Idiomas disponibles
• The pump cannot be installed in Zone 0 (Z0) or Zone 1 (Z1). To see drawings
refer to page 7.
• See the maximum total head (H max), in meters on the back cover of the
manual specific to each range of pump.
• The unit should be connected to an alternating current supply (see data on the
pump' s plate) with an earth connection, protected by a residual current device
(RCD) with a rated residual operating current that does not exceed 30 mA.
• A disconnector must be fitted to the fixed electrical installation in accor-
dance to the installation regulations.
• Failure to heed the warnings can cause serious damage to the pool' s equipment
or serious injury, including death.
• Observe the regulations in force on accident prevention.
• Before handling the unit, ensure that the power supply is switched off and
disconnected from the mains.
• If the unit breaks down, do not try to repair it yourself. Contact a qualified
service engineer instead.
• All modifications to the pump require the manufacturer's prior authoriza-
tion. Spare parts and original accessories authorized by the manufacturer
ensure greater safety. The pump's manufacturer may not be held liable for
any damage caused by unauthorized spare parts or accessories.
• Do not touch the fan or moving parts and do not place a rod or your fingers
near the moving parts while the device is running. Moving parts can cause
serious injury or even death.
• Do not dry-run the pump or without water (the warranty will become null
and void).
• Do not do any maintenance or repair work on the device with wet hands or
if the device is wet.
• Do not submerge the device in water or mud.
• Pumps without indication that they are protected against the effect of
freezing shall not be left outside during freezing weather conditions.
• The Pump is intended to be used in household and indoor environments and
is not suitable to be used in commercial areas.
Installation and general maintenance manual
- SELF-PRIMING POOL PUMPS
5
