Tramontina GURU Manual De Instrucciones página 60

The cooktop stops heating during use. Check if:
• The ambient temperature is too high.
• The air intake for ventilation is blocked.
• Timer has turned off the product because it has reached the programmed time.
• There was overheating and the cooktop was switched off by the safety device.
Error
ERR. 1
IGBT TEMP
ERR. 3
NO SENSOR
ERR. 4
HIGH TEMP
ERR. 5
OVERLOAD
ERR. 6
VOLTAGE
ERR. 7
CIRCUIT FAULT C
ERR. 8
CIRCUIT FAULT P
ERR. 14
ERROR POWER
ERR. 9
IGBT SHORT
CIRCUIT
ERR. 10
LONG PERIOD
ERR. 15
CLEAN PANNEL
HOT
60
Manual de Instruções Cooktop Portátil Inteligente por Indução Tramontina
Cause
Overheating
Temperature sensor disconnected
Overheating on the glass ceramic
table
Weight detected above maximum
allowed (20 kg)
Voltage above or below the limit
acceptable
Communication failure between
control board and the control
board power
Power board failure
Communication failure between
board power and the control board
Power board failure
Maximum time operation
(3 hours cooking or 4 hours total)
If the "+" or "-" keys remain
pressed by more than 9 seconds,
the display is blocked
Indication of residual heat.
The glass ceramic table is in a
temperature above 60 °C (140 °F)
Check that the ventilation vents are
blocked. If not, contact the Service
Contact your Authorized Service.
The temperature in the pan can be very
high, so wait for it to cool down. If the error
persists, contact the Service Authorized.
Reduce the weight applied to the cooktop.
Check the voltage of your residence.
Contact your Authorized Service.
Contact your Authorized Service.
Contact your Authorized Service.
Contact your Authorized Service.
After 30 seconds, it will be possible to
restart the cooktop operation
Wait 2 seconds without pressing no key
and the display will be unlocked.
The code will disappear as soon as the
table glass ceramic reach a temperature
Table 2
Solution
Authorized.
below 60°C. (140 °F).