Idiomas disponibles
Idiomas disponibles
3. Open the dispenser by
pushing up on the release
latch. The latch is on the
bottom back edge of the
dispenser in the center.
(See Figure 8)
NOTE: See "Keyed
Locking Option" if you
would like to convert
your dispenser to a
keyed system.
4. While pushing the release
latch, open the dispenser
by placing your other hand
on the top and guiding the
front cover forward. Apply
pressure from inside the
dispenser over the taped
area. (See Figures 9-10)
NOTE: Allow dispenser
to remain empty for a
minimum of 8 hours
before loading.
SCREW MOUNTING
IMPORTANT! Dispenser
opens to the front. For
ideal placement, the
dispenser should be
mounted 3" above
any countertop, fixture
or obstruction, and
2" below any cabinet,
fixture or obstruction.
(See Figure 11)
1. Clean the mounting surface
thoroughly using any type of
general purpose cleaner
and a paper towel.
(See Figure 12)
NOTE: Ensure surface is
completely dry before
proceeding.
PAGE 2 OF 12
INSTALLATION CONTINUED
Figure 8
Figure 9
Figure 10
Figure 11
2"
11"
7.5"
3"
Figure 12
2. Open the dispenser by
pushing up on the release
latch. The latch is on the
bottom back edge of the
dispenser in the center.
(See Figure 13)
NOTE: See "Keyed
Locking Option" if you
would like to convert
your dispenser to a
keyed system.
3. While pushing the release
latch, open the dispenser
by placing your other hand
on the top, and guiding
the front cover forward.
(See Figure 14)
4. Hold the dispenser against
the wall in the proper
position and mark the
appropriate slots. Drill holes
in marked slots. Attach
dispenser to the wall with
the wall anchors and screws
provided. You may choose
to remove a portion of the
protective backing from
the tape to help hold the
dispenser in position as you
complete the installation.
(See Figure 15)
KEYED LOCKING OPTION
For added security, your new foam dispensing
system has a keyed locking option.
NOTE: The dispenser has been shipped to you
in the manual, no key required mode. The
conversion to keyed locking mode can be
completed before or after the installation.
1. Open the dispenser by
pushing up on the release
latch. The latch is on the
bottom back edge of the
dispenser in the center. While
pushing the release latch,
open by placing your other
hand on the top, and guiding
the front cover forward.
(See Figure 16)
Figure 13
Figure 14
Figure 15
Key
Figure 16
0324 IH-3415
