Dea PASS Serie Instrucciones De Uso página 24

5.1 ELECTRICAL CONNECTIONS FOR 24V MODELS
In case you have to operate on the control panel (for wiring, adjustments etc...), remove the circuit support plate. To do this, pro-
ceed as follows (Picture 12):
• unscrew the fixing screws of the control panel holder plate, without removing them;
• Unhook the plate of the barrier case as shown;
• Move the control panel box into a most comfortable position and perform the necessary tasks;
Execute the wiring following the directions of "Table 1" and diagrams on page 23.
WARNING To ensure an appropriate level of electrical safety always keep the 230V power supply cables apart (minimum 4mm
in the open or 1 mm through insulation) from low voltage cables (motors power supply, controls, electric locks, aerial and auxiliary
circuits power supply), and fasten the latter with appropriate clamps near the terminal boards.
WARNING Connect to the power supply 230 V ~± 10% 50 Hz through a multi pole switch or a different device that can ensure
multi pole disconnection from the power supply, with a contact opening of 3 mm.
WARNING To connect the encoder to the control panel, use only a dedicated cable 3x0,22mm
1-2 +24 V
3-4 22 V ~ transformer power supply input
24 V
5-6
indications).
7-8 Operator 1 output
9 Connection of motors metallic parts
10-11 Operator 2 output (if present)
12-13 24 V
Electric-lock output max 1 art. 110 (if P062=0), 24V
14-15
brake output for reversible motors (if P062=3)
16-17 24 V
18 - N.C.
18-19
19 - Com
20 - N.C.
20-21
21 - Com
22 - N.O.
22-23
23 - Com
24 - N.O.
24-25
25 - Com
26 - N.C.
26-27
27 - Com
28 - N.O.
28-29
29 - Com
30 Aerial signal input
31 Ground aerial input
32-33 DEA_NET net input (unused at the moment)
CON 1 230 V ~ ±10% (50/60 Hz) power supply input
Encoder selection Jumper:
J5 J9
•A position = operators with encoder (remind to set P029=0)
B A B A
•B position = operators without encoder (remind to set P029=1)
22
Table 1 "terminal board connections"
power supply output for auxiliary devices 200mA
battery power supply or photovoltaic accumulator Green Energy input (follow carefully polarity
max 15 W output for open gate fix/flashing warning light (if P052=0/1) or courtesy light (if P052>1)
Flashing light output max 15W art. Lumy/24A/S
Input 6 FCC 1. If it intervenes it stops M1 closing. If unused, short circuit.
Input 5 FCA 1. If it intervenes it stops M1 opening. If unused, short circuit.
Input 4. Unused.
Input 3. Unused.
Input 2 PHOTO 1. When enabled (see parameter P050 in the table), activation of
PHOTO 1 provokes: an inversion of direction (during closing), the arrest of the mo-
vement (during opening), prevent the start (gate closed). If unused, short circuit.
Input 1 START. In case of intervention it provokes: the operator opening or closing. It
may operate as "inversion" mode (P49=0) or "step by step" mode (P49=1).
.
2
output max 5W configurable (if P062≠0) or electro-