Idiomas disponibles
Idiomas disponibles
OPERATION - General information
The below description goes with the image on page 2.
1. Hose connection
2. Cable reel-in button
3. Vacuum-cleaner handle
4. On/off switch with
5. Parquet brush tool
6. Furniture nozzle
7. Dusting brush
8. Crevice tool
9. Dust receptacle
See page 3 for the images referenced in the description.
OPERATION
1. Push the hose into the hose connection on the motor unit (see figure 1). To remove the hose, push the
two buttons and pull it out of the hose connection.
2. The power cord has a yellow (B) and red (A) mark (see figure 2). Pull out the cord to the yellow mark.
3. Slide the hose handle into the telescopic tube (see figure 3A).
4. Press the button on the telescopic tube and keep it pressed in; you can then extend or retract the tube
to the required length (see figure 3B).
5. Press the foot button on the nozzle to set the combi nozzle for use on hard or soft surfaces, (see figure
3C). For use on hard surfaces, press the foot button on the combi nozzle to extend the brushes. Lift the
button for use on soft surfaces.
6. Put the plug in the wall socket, and press the On/Off switch. To switch off the appliance, press the On/
Off switch again (4).
7. The appliance is now ready for use. You can move the vacuum cleaner while you are cleaning by
pulling on the hose grip. You can lift the appliance with the vacuum cleaner's handle (3).
8. You can adjust the vacuum suction with the vacuum suction control (see figure (5). It is advisable to
reduce the vacuum suction when cleaning upholstered furniture and curtains. This will prevent the
fabric from being sucked into the nozzle.
9. In addition, you can use the electronic suction power regulator (18) to determine how much suction power
you want to use.
WARNING:
• Never pull out the power cord beyond the red mark (A). This could damage the power cord.
• For wooden flors we reccomend you to use the special hard floor brush
OPERATION - STORAGE AFTER USE
1. Remove the plug from the wall socket.
2. Press the rewind button and keep it pressed in; the power cord will automatically rewind onto the reel.
3. An attachment slot for the combi nozzle is fitted to the back of the vacuum cleaner. This avoids the
need to dismantle the vacuum cleaner after use; you can store the assembled appliance and retrieve it
again quickly when you need it.
WARNING:
• Guide the power cord whilst it rewinds onto the reel, since otherwise the cord could become tangled or
the plug could strike the back of the appliance. Take hold of the power cord near the mark, and allow it
to gently slide through your fingers back into the appliance (see figure 5).
CLEANING AND MAINTENANCE - Cleaning the housing
1. Remove the plug from the wall socket.
2. Clean the outer surface of all parts with a damp cloth and a cleaner suitable for plastics.
3. Over the course of time dust and dirt can accumulate around the wheel axles, thereby preventing the
wheels from turning easily. Consequently they should be kept clean.
WARNING:
• Never immerse the appliance, plug or power cord in water.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
10. Hose
11. Grip with adjustable air opening
12. Telescopic tube
13. Dust container release button
14. Exhaust filter
15. Rear wheels
16. Combi nozzle
17. Dust separation system
18. Electronic suction power regulator
18
18
EN
EN
