Idiomas disponibles
Idiomas disponibles
DANGER
Electricity presents a risk of fatal accident! Contact with electrically live lines can lead to severe physical
injury and/or death.
▶ The product is not insulated!
▶ Do not use on electrically live lines!
WARNING
Risk of injury due to oil escaping under high pressure! Oil escaping under high pressure can injure the
skin and the eyes.
▶ Do not use the pump if damage is visible.
▶ Do not use the pump if oil escapes.
▶ Make sure that the piston retracts after every work operation.
▶ If the piston does not retract after the work operation, press the reset button for manual retraction.
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before inserting, changing or removing the crimping, pressing or punching head.
1. Check the oil level. → page 10
2. Close the hydraulic hose.
3. Connect the required crimping, cutting or punching head.
4. Bring the crimping, cutting or punching head to the working position.
5. Press and hold down the non-latching rocker switch on the pump.
6. Hold the non-latching rocker switch on the pump down until the crimping, cutting or punching operation
has completed.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
•
Carefully remove stubborn dirt.
•
Carefully clean the air vents, if present, with a dry, soft brush.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
•
Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
•
Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
•
Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
•
Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Maintenance
•
Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
•
Do not use the product if signs of damage are found or if parts malfunction. Immediately have the product
repaired by Hilti Service.
•
After cleaning and maintenance, install all guards and protective devices and check that they are in full
working order.
*2321740*
2321740
English
11
