Parkside PPS 40 B3 Instrucciones De Funcionamiento Y De Seguridad página 16

Cortador de plasma
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 148
The device must be free-standing with a
gap of at least 0.5 m all around.
Ventilation slots must not be blocked or
covered.
The device must not be used as a storage
place and tools or other items must not
be placed on the device.
It must be operated in a dry and
well-ventilated working environment.
• Connecting compressed air
NOTE!
fThis device is designed for operating
pressure (output pressure at the com-
pressor) of up to 6.3 bar. Please bear in
mind that the pressure can lower while
setting the air pressure. Thus, in a hose
length measuring 10 m and an internal
diameter of 9 mm it drops by approx.
0.6 bar.
The compressed air source must have a filter
and regulator.
Connect the compressed air hose
the back of the plasma cutter
compressed air connection
insert the side of the compressed air hose
16
without quick connector into the
compressed air connection
plasma cutter
1
The pressure can be set via the knob
on the condensate separator (see
Fig. I–L). Select a pressure of 4–4.5 bar.
In order to release the compressed air
hose
16
, you must press the locking
mechanism of the compressed air
connection
20
and pull out the com-
pressed air hose
(see Fig. I).
16
GB/IE/NI/CY/MT
16
1
to the
20
. To do so,
20
of the
(see Fig. I).
16
at the same time
• Connecting the cutting
burner
Pull the cover cap
burner connection socket
Insert the plasma burner plug
plasma burner connection socket
and tighten the union nut hand-tight
(see Fig. A+B).
Insert the plasma burner control plug
into the plasma burner control socket
and tighten the union nut hand-tight
(see Fig. A+B).
• Connecting the earthing
cable
Connect the earthing clamp device plug
with the earthing clamp connecting socket
. Then connect the earthing clamp plug
11
with the earthing clamp connecting plug
Make sure that the connecting shaft is first
connected and then turned. The connecting
shaft of the earthing clamp device plug
on
must point upwards when plugging in.
5a
After plugging in, the connecting shaft must
be rotated in a clockwise direction until it
reaches the stop, in order to lock it in place
(see Fig. A+B). This does not require force!
• Using the device
21
• Operation
1. Set the plasma cutter
well ventilated area.
2. Position the machine in the vicinity of the
workpiece.
3. Press the on/off switch
4. Clamp the earthing clamp
workpiece to be cut and make sure that
there is a good electrical contact.
5. Set the cutting current on the current
controller
12a
off the plasma
12
.
up in a dry and
1
17
.
4
13
. If the arc beam is inter-
7
into the
12
6
10
5a
5
.
5b
onto the
loading