Machine Start And Stop; Machine Operation (Scrubbing/Drying) - Nilfisk-Advance Micromatic 13 Instrucciones De Uso

ENGLISH

MACHINE START AND STOP

Starting the machine
Prepare the machine as shown in the previous paragraph.
1.
Turn the parking lever (24) to position (24a).
2.
Drive the machine by pushing it with the hands on the handlebar (2).
3.
Connect the power supply cable (10) to the electrical mains.
4.
WARNING!
Before connecting the power supply cable to the electrical mains, check that frequency and voltage, shown on
the machine serial number plate (1), match the electrical mains voltage.
Turn the knob (5) to the suitable program.
5.
(5a) brushes - vacuum system - solution flow activation
•
(5b) brushes - solution flow activation
•
• (5c) vacuum system activation
(5d) fitted carpet cleaning and floor wiping (optional)
•
Turn on the machine by pressing the switch (6) and start cleaning the floor.
6.
Stopping the machine
Turn off the machine by pressing the switch (6).
7.
Disconnect the power supply cable (10) from the electrical mains.
8.
Lift the brush/pad-holder by turning the transport/parking device (24) to position (24b).
9.

MACHINE OPERATION (SCRUBBING/DRYING)

Start the machine as shown in the previous paragraph.
1.
While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the floor.
2.
CAUTION!
To avoid damaging the floor surface, do not use the brushes without the solution and, when the machine is not
operating, stop the brush/pad-holder by pressing the program (5c or 5d), or by pressing the switch (6).
CAUTION!
Before lifting the brush/pad, turn it off by pressing the switch (6).
12
INSTRUCTIONS FOR USE
14 25 18 17
5 5a 5b 6
5c 24
5d
9097508000(1)2008-03
14a
10
11
1
16 15
24a
Micromatic™ 13E
2
7
26
19
24b
P100166B