Idiomas disponibles
Idiomas disponibles
INSTALLATION
INSTRUCTIONS
11
CONNECTING
THE DRAIN
HOSE
The drain hose should
always
be properly
secured.
Failure to properly
secure the drain hose can result in
flooding and property damage.
The drain must be installed
in accordance
with any
applicable
local codes and regulations.
Make
sure
that the
drain
hose
is not stretched,
pinched,
crushed,
or kinked.
or clothing
damage.
OPTION
2: LAUNDRY
TUB
Bend the end of the drain hose to the desired
shape
and support
it on the edge
of the laundry
tub. Use
Drain Hose
OPTION
I: STANDPIPE
Bend the outlet
end of the drain
hose to form
a U
shape.
Insert the end of the drain hose into the drain.
If the drain is large enough
for the flange
on the hose
to fit inside,
do not insert
the flange
more
than
1-2
inches
into the drain. Use the tie strap included
with
the installation
materials
in the foam
block in the tub
to secure
the drain hose to the drain.
If the water
valves
and drain are built into the wall,
fasten
the drain hose to one of the water
hoses with
the tie strap (ribbed
side on inside).
If your drain is a standpipe,
fasten
the drain hose to
the standpipe
with
the tie strap provided.
Tie Strap
Te Strap
NOTE:
Normal
height
of the end of the hose should
be ap-
proximately
35"-47"
(0.9-1.2
m) from the floor.
Do not install the end of the drain hose lower than
29" (73.7
cm)
or higher
than
96 in. (243.8
cm)
above the bottom
of the washer
or more
than
60
in. (152.4 cm) away from the washer.
Never
create
an air-tight
seal between
the drain
hose and the drain, using tape or other
methods.
If
no air gap is present,
water
can be siphoned
out of
the tub resulting
in poor wash/rinse
performance
Drain Hose
the tie strap to secure the drain hose in place.
