OPERATING INSTRUCTIONS
NOTE
The following instructions are for the control
panel. The same instructions can be used for
the remote control.
TO TURN UNIT ON:
DO THIS:
PRESS ON/OFF BUTTON
YOU WILL SEE:
NOTE: The unit will run in Cool mode with
Eco feature and Auto fan speed setting
when used for the first time. With the Eco
feature, when the room temperature is below
the set temperature, the fan will continue to
run for 3 minutes after the compressor shuts
o . The fan then cycles on for 2 minutes at 10
minute intervals until the room temperature
is above the set temperature, at which time
the compressor turns back on. Eco feature
can be activated or deactivated by pressing
the Eco button, and cannot be activated in
'fan only' mode.
TO CHANGE TEMPERATURE SETTING:
DO THIS:
PRESS
PRESS
TO RAISE
TO LOWER
YOU WILL SEE:
The display will show the set temperature
during normal operation, press either up ( + )
or
down
( – )
temperature to desired setting. If the up ( + )
or down ( – ) button is pressed continuously,
the
unit
will
beep
temperature setting reaches the upper/lower
limits 90°F or 60°F.
TO ADJUST FAN SPEEDS:
DO THIS:
PRESS TO SELECT
YOU WILL SEE:
TO SET TO AUTO FAN:
DO THIS:
PRESS FAN BUTTON,
UNTIL AUTO IS HIGHLIGHTED
15
buttons
to
adjust
twice
when
the
the
