Idiomas disponibles
Idiomas disponibles
OPERATION
Note: Reset the control panel to its default settings after assembly.
Note: Only do this once the desk has been completely assembled.
1.
Restoring default settings (calibration)
Press and hold the RST button "
go. The desk will automatically move up and down to find its highest and lowest
positions. The system will automatically return to its default settings.
2.
Height adjustment
Press and hold the "
for the work surface to move upwards until it reaches its highest point. Press the button
again when the desired position is reached.
Press and hold the "
for the work surface to move downwards until it reaches its lowest point. Press the
button again when the desired position is reached.
Warning: If the desk is lowered without using the memory function, the automatic height
adjustment will stop at 76cm for safety reasons. From this height, the table will need to
be lowered manually to reach the lowest setting of 72cm.
3.
Memory and operation
Standing height memory:
Move the work surface to the desired standing height, press and hold " " for 3 seconds:
the display will flash and the position is saved.
Sitting height memory:
Move the work surface to the desired sitting height, press and hold " " for 3 seconds:
the display will flash and the position is saved.
If you now press the " " or" " button, the work surface will move automatically
to the height of the stored position and can be stopped as required by pressing the
button again.
Note: The standing height must be higher than the sitting hight when saving to the
memory, otherwise the setting cannot be stored.
4.
Movement reminder function (countdown feature)
There are 3 countdown time settings: T30=30 minutes, T45=45 minutes, T60=60 minutes.
Start the countdown by briefly pressing "
and the countdown starts.
End the countdown by briefly pressing "
When the countdown has finished, the display on screen will flash for 1 minute. Press
any button to end this.
If the desk isn't used after 5 consecutive reminders, the function turns off automatically.
MAINTENANCE AND CARE INSTRUCTIONS
Always switch off the appliance and disconnect the mains plug before carrying out maintenance
or checks.
" for 3 seconds until "
" button until the display flashes
" button until the display flashes
" so that "[30/45/60]" displays in succession
" to display the number on screen.
9
" appears on screen, then let
---
www.DEUBAXXL.de
