Idiomas disponibles
Idiomas disponibles
• First familiarise yourself with the hair clippers and try to hold them so that the on/off but-
ton can be pressed at any time. Please make sure that you hold it securely in your hand.
• Comb the hair thoroughly first.
• Adjust the comb attachment to obtain the desired cutting length.
If you are not sure which cutting length is right for you, start with a long setting and then
change to a smaller one if needed.
Switch on the hair clippers with the on/off button.
Always switch on the hair clippers first before you start cutting. This will prevent the blades
from getting blocked.
Apply the hair clippers so the face of the cutter block can move parallel to the skin. Always
move the hair clippers through the hair as evenly as possible.
To avoid injury or skin irritation when cutting in folds of the skin or areas with thinner skin,
you should stretch the skin with your fingers.
• Start cutting the hair at the back of the neck or sides and cut towards the crown. Then cut
the hair at the front, also towards the crown.
• Ideally you should cut against the direction of hair growth.
• To cut all of the hair, move the hair clippers over the same section of hair several times.
• Combing through the hair occasionally is recommended.
• For cutting lengths longer than 0.47 inch (12mm), it is useful to move the hair clippers through
the hair several times in different directions. This results in an even, homogeneous cut.
• You can also use the hair clippers without the comb attachment. Without the comb attach-
ment the hair is cut close to the roots. This application is also suitable for cutting contours
and trimming sideburns.
C utti ng C ontou rs
Apply the front edge of the cutter block at the desired height of the hairline. Now move the
hair clippers down with in an even motion.
B ea rd Tri mm i n g
• Comb the beard in the direction of growth with the supplied comb.
• Trim the beard downward starting from the ear. first trim one side and then the other side.
• If you want to trim the beard very short, for trimming a moustache, or to cut contours, use
the hair clippers without a comb attachment.
• Vary the cutting length as needed by adjusting comb attachment 11 accordingly.
• To trim the moustache, comb it straight down with the supplied comb. Start trimming in
the middle over the mouth and work your way out from there to one side and then the other.
Em pt yi n g th e Hai r Rese r voi r
•
To do so, flip open the hair reservoir cover to the right and empty.
•
You can remove any remaining hair with the cleaning brush.
•
Then close the hair reservoir cover to restore the vacuum func-
tion. You must hear the cover lock into place.
E NGLI SH
11
