Possible Errors And Their Resolution; Signals To Observe - KUKKO Y-57 Serie Instrucciones De Uso

KUKKO Tool factory
Series Y-57
EN
36
Warning: Do not overload the hydraulic nut splitter under any
circumstances. Monitor the pressure gauge. Do not exceed the
maximum pressure.
6. Open the hydraulic pump's release valve. The splitting chisel will
now retract.
7. Lift the nut splitter away from the split nut.
8. Set up the nut splitter on the opposite side and repeat the
splitting process.
9. Remove the split nut and the nut splitter.
10. Release all pressure in the hydraulic nut splitter. Uninstall the
nut splitter in reverse order of how you installed it.
11. Store the hydraulic nut splitter again, as specified in the
instructions.

6.2. Possible errors and their resolution

# description of error
1 trapped pressure in the
hydraulic system.
2 Splitting chisel does not
move.
3 Cylinder extends at an
abnormally slow pace

6.3. signals to observe

Monitor the pressure gauge at all times during operation. The
pressure gauge shows the current pressure in the hydraulic
system.
Cause of error
A valve is defective.
Cylinder piston sticks
Coupling on a valve is not
completely tightened.
resolution of error
Have a trained hydraulics
technician resolve the
problem.
Have the cylinder
serviced by the manu-
facturer or by a trained
hydraulics technician.
Check all connections
and valves and tighten
them if necessary. if
necessary, disassemble
and reassemble the
hydraulic system.
A world in motion
since 1919!