Idiomas disponibles
Idiomas disponibles
GB
1. About this document
Please read carefully and keep in a safe place.
• Under copyright. Reproduction either in whole or
in part only with our consent.
• Subject to change in the interest of technical
progress.
Symbols
!
Hazard warning!
Reference to other information in
...
the document.
2. General safety precautions
Disconnect the power supply before
!
attempting any work on the unit.
• During installation, the electric power cable being
connected must not be live being connected
must not be live. Therefore, switch off the power
first and use a voltage tester to make sure the
wiring is off-circuit.
• Installing the sensor-switched light involves work
on the mains voltage supply. This work must
therefore be carried out professionally in accord-
ance with national wiring regulations and electri-
cal operating conditions. (e.g. DE: VDE 0100,
AT: ÖVE / ÖNORM E8001-1, CH: SEV 1000)
3. L 800 C / L 810 C / L 800 SC /
L 810 SC / L 820 SC
Light enclosure
1
Wall mount
2
Bottom cover
3
Top cover
4
Mains lead, concealed wiring
5
Mains lead, surface wiring
6
Mounting hook to simplify installation /
7
cable strain relief grips
Spacers for surface wiring
8
House number panel (L 820 SC)
9
Retaining screws for house number panel
10
(L 820 SC)
4. Principle
Sensor-switched light with an active motion detec-
tor. The integrated iHF sensor emits high-frequency
electromagnetic waves (5.8 GHz) and receives their
echo. Any movement by persons in the light's de-
tection zone is noticed by the sensor as a change
in echo. A microprocessor then issues the switch
command "switch light ON". Detection is possible
through doors, panes of glass or thin walls.
(L 800 C / L 800 SC / L 810 C / L 810 SC /
L 820 SC)
Note:
When installing, please always allow a distance of
at least 3 m to Wi-Fi routers or access points.
The functions of the sensor-switched light can
be set via smartphone and tablet or control dial.
Bluetooth interconnection is only possible via smart-
phone or tablet. (L 800 SC / L 800 C / L 810 SC /
L 810 C / L 820 SC)
Detection zones for wall mounting:
1) Minimum reach (1 m)
2) Maximum reach (5 m)
1)
1)
A
Note:
If lights are mounted too close together, switching
errors may occur as the high-frequency signals
emitted will interfere with each other (Fig. A).
– 13 –
2)
2)
10
10
5
5
B
C
GB
