Idiomas disponibles
Idiomas disponibles
When tool life has expired, it is recommended to:
• disassemble the tool.
• degrease the tool.
• separate tool parts by material for correct recycling.
Tool repair and maintenance should be conducted by an Authorized Service Center.
Refer all communications to the nearest Ingersoll Rand office or distributor.
Manuals are available at ingersollrand.com
Table 1. Product Information Manuals
Publication
Product Safety Information Manual
Product Information Manual
Product Parts Information Manual
Product Installation Manual
Product Maintenance Manual
Declaration of Conformity
ZG Installation Retrofit Kit
Product Description
The Zero Gravity Air Balancer provides the ability to electronically move loads up and down using the handle actuators or apply force directly
to a lifted load.
● To reduce the risk of electric shock, do not expose to rain. For Indoor use only.
● Do not operate Electropneumatic balancers in explosive atmospheres, such as the presence of flammable liquids, gases or dust.
Electropneumatic balancers create sparks which may ignite the dust or fumes.
● Controller must be used by a single operator. Simultaneous command inputs may result in hazardous movements.
Specifications
This device needs to be connected to a standard E type plug or B type plug (for other option, contact factory). It works from 100-150 V AC at
50 to 400Hz and the power consumption is 3.5A Max. This system is protected by 2 fuses (characteristics: T type, dimension 5x20 mm, 3.15A
250 V AC). Working pressure of 100 psi (6.9 bar) dry and clean air (30 microns filter must be used).
Model Code Explanation
Example:
Type of Control Kit
ZG
=
Zero Gravity
2
=
Gen 2
Wire
W
=
Wire Rope
Capacity
015
=
150 lb. (68 kg)
020
=
200 lb. (91 kg)
035
=
350 lb. (158 kg)
050
=
500 lb. (227 kg)
Inches of Travel
080
=
80 in. (203 cm)
120
=
120 in. (305 cm)
S
=
Z-Stop
Type of Suspension Kit
00
=
No Suspension
AT
=
ZRAT Rail
A1
=
ZRA1 Rail
A2
=
ZRA2 Rail
HM
=
Top Hook Mount
S2
=
ZRS2 Rail
Type of Hook
B
=
Bullard
C
=
Steel Snap
Note:
a. Gen 1.0 can be converted to Gen 2.0 by ordering handle part number 47808627001 (Bullard Hook Handle) or 47805074001 (Steel Snap
Hook Handle) and software update.
b. Standard balancer can be converted to Gen 2.0 by ordering respective Kit. Suspension to be ordered separately based on the requirement.
47804819_ed3
ZG
2
W
020
Refer to Zero Gravity Balancer 2.0 - Kit List on page 210.
CCN
16598831
54072541
16598849
47646669
16598856
47808318
47804820
CAUTION
NOTICE
120
S
00
B
EN
EN-1
