Idiomas disponibles
Idiomas disponibles
EN
Note: Max weight must not exceed 80% of the ZG balancer capacity.
4. Load is moving up and down but sometimes it's a jerky motion or not working or a red light is blinking in the Control Box.
• This will occur when the operator is moving the load in the handle mode up and down in faster rate.
• This will cause the ADC value in load cell reaching more than Max weight. Hence a red light will blink not allowing the system to go up.
• This is a concept intentionality included in the system to avoid incorrect usage of the ZG balancer.
• In such case, get the load down, turn OFF the system for 10 seconds and turn ON/press the green button. Then operate the handle gently.
5. Load is on the ground but the handle is not moving further down.
• This is an indication of interlock or load balancing.
• In such case, connect the control box to system and open GUI tool.
• If any value is displayed on the last interlock weight or last no load balancing weight, clear it by ticking the box and press on "Write settings"
to update in system.
EN-12
47804819_ed3
